GB 11568-1999 Automobile hood (lid) lock system
Basic Information
Standard ID:
GB 11568-1999
Standard Name: Automobile hood (lid) lock system
Chinese Name:
汽车罩(盖)锁系统
Standard category:National Standard (GB)
state:in force
Date of Release1999-11-01
Date of Implementation:2000-08-01
standard classification number
Standard ICS number:Road vehicle engineering>>Road vehicle installation>>43.040.60 Body and body accessories
Standard Classification Number:Vehicles>>Car chassis and body>>T26 body (cab) and accessories
associated standards
alternative situation:GB 11568-1989
Procurement status:EQV FMVSS-113
Publication information
publishing house:China Standard Press
other information
Release date:1989-08-10
Review date:2004-10-14
Drafting unit:Changchun Automotive Research Institute
Focal point unit:National Automotive Standardization Technical Committee
Publishing department:State Administration of Quality and Technical Supervision
competent authority:National Development and Reform Commission
Introduction to standards:
This standard specifies the requirements for the engine hood (cover) locking system located in front of the windshield of the vehicle (or the front trunk of a rear-engine vehicle). This standard applies to Class M and Class N vehicles. GB 11568-1999 Automotive hood (lid) lock system GB11568-1999 Standard download and decompression password: www.bzxz.net
Some standard content:
GB11568.-1999
Previous
Preface
The technical content of this standard is equivalent to the requirements of the US Federal Motor Vehicle Safety Standard (FMVSS) No. 113. This standard specifies the safety requirements that automobile hood locking devices should meet to ensure safe driving of the automobile. This standard will replace GB11568-1989 from the date of implementation. This standard is proposed by the State Administration of Machinery Industry. This standard is under the jurisdiction of the Jinguo Automobile Standardization Technical Committee. This standard was drafted by: China Automotive Technology and Research Center. The main drafter of this standard: Wang Yang.
215
1 range
National Standard of the People's Republic of China
Car hood (lid) lock system
Motor vehicles-Hood latch systemGB11568---1999
Replaces GB11568-1989
This standard specifies the requirements for the engine (or front trunk of a rear-engine car) hood (lid) locking system located in front of the windshield of the automobile.
This standard applies to Class M and Class N vehicles. bzxz.net
2Definitions
This standard adopts the following definitions.
2.1 Cover (cover)
An outwardly movable body panel located in front of the vehicle windshield to protect and cover the engine, luggage or storage. 2.2 Cover) lock device
A device that keeps the cover (cover) locked with the body and can be opened. 3 Requirements
3.1 The car hood (cover) must be equipped with a hood (cover) locking device. 3.2 If the hood (cover) will obstruct the driver's forward vision in a certain position after it is opened, the hood (cover) lock device used for the hood (cover) must have a secondary opening function, or the hood (cover) must have a secondary opening function. ) is equipped with a second cover (cover) locking device. Approved by the State Administration of Quality and Technical Supervision on 1999-11-01 216
Implemented on 2000-08-01
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.