JB/T 2462.28-1999 Dimensions of multi-station movable worktables for common components of modular machine tools
Basic Information
Standard ID:
JB/T 2462.28-1999
Standard Name: Dimensions of multi-station movable worktables for common components of modular machine tools
Chinese Name:
组合机床通用部件 多工位移动工作台 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Machinery manufacturing>>machine tool devices>>25.060.99 Other machine tool devices
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J58 Combined Machine Tools
Publication information
other information
Focal point unit:National Metal Cutting Machine Tool Standardization Committee Combined Machine Tool Branch
Publishing department:National Metal Cutting Machine Tool Standardization Committee Combined Machine Tool Branch
Introduction to standards:
JB/T 2462.28-1999 This standard is a revision of JB 3558-83 "Dimensions of multi-station mobile worktables for common components of modular machine tools". Only editorial changes have been made in accordance with relevant regulations, and the main technical content has not changed. This standard specifies the nominal dimensions and interchangeable dimensions of multi-station mobile worktables for modular machine tools. This standard applies to multi-station mobile worktables for modular machine tools and their automatic lines. This standard was first issued in 1983. JB/T 2462.28-1999 Dimensions of multi-station mobile worktables for common components of modular machine tools JB/T2462.28-1999 Standard download decompression password: www.bzxz.net
Some standard content:
1C25.6.99
Machinery Industry Standard of the People's Republic of China
JB/12462.1~2462.28-1999
Common Components for Combined Machine Tools
Published on 1990-05-21
State Machinery Industry Bureau
2(MI-01-1 Implementation
JB/T1462.2-1999
This standard is designed on the basis of B3558-83 "Dimensions of multi-position ball movable tables for common components of machine tools". In addition to eliminating the non-standard and re-editing it according to the relevant provisions, it has been revised in terms of structural dimensions. This standard has replaced JB3558-83 since its implementation. This standard was proposed by the National Technical Committee for Standardization of Metal Cutting Machine Tools. This standard was drafted by the National Technical Committee for Standardization of Metal Cutting Machine Tools, Combined Machine Tool Branch. The responsible drafting unit of this standard: Dalian Combined Machine Tool Research Institute This standard was first issued in 1983,
Machinery Industry Standard of the People's Republic of China
Common Components of Combined Machine Tools
Dimensions of Multi-position Moving Tables
This standard is It specifies the nominal dimensions and joint dimensions of the differential multi-section action. This standard is applicable to the multi-position action table of modular machine tools: 2 Nominal dimensions
JH/3:2462.2H-1599
Transfer method 1 The necessary dimensions of the table are determined by the width of the saddle W: 470mm, 50mm, 630mm, 800mm: four specifications
3 Interchangeable dimensions
The dimensions of the mobile table are in accordance with Figure 1 and Table 1. The dimensions are the whole effective multiples of mm: Www.bzxZ.net
21,=L,+5-a+b,
3, small,
Approved by the State Machinery Industry Bureau on May 20, 1999 and implemented on January 1, 2000
JI/T 2462.28—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.