JB/T 8036.1-1999 Machine tool fixture parts and components screw supports
Basic Information
Standard ID:
JB/T 8036.1-1999
Standard Name: Machine tool fixture parts and components screw supports
Chinese Name:
机床夹具零件及部件 螺钉支座
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
publishing house:China Machinery Industry Press
Publication date:2000-01-01
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:State Machinery Industry Bureau
Introduction to standards:
This standard specifies screw supports with thread specifications of M6 to M24. JB/T 8036.1-1999 Machine tool fixture parts and components screw supports JB/T8036.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Bureau of Machinery Industry
Implementation on 2000-01-01
1 Scope
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesSerewrest
The parts and units of jigs and fixturesSerewrest
This standard specifies the screw supports with thread specifications of M6 to M24. 2 Reference standards
JB/T8036.1-1999
Replaces JB/T 8036—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards GB/T97.1—1985 Flat washers Grade A
GB/T699—1988
Technical conditions for high-quality carbon structural steel
JB/T8044—1999 Technical requirements for machine tool fixture parts and components 3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Bureau of Machinery Industry on August 6, 1999 Type B
Implemented on January 1, 2000www.bzxz.net
Basic dimensions
Limited tolerances
Technical conditions
JB/T 8036.11999
4.1Material: 45 steel in accordance with the provisions of GB/T699. 4.2Heat treatment: 35~40HRC.
Other technical conditions in accordance with the provisions of JB/T8044. 4.3
Marking example:
d-M8, 1-10mm A-type screw support:
AM8×10JB/T 8036.1—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.