JB/T 10402.2-2004 Off-grid wind turbine yaw system Part 2: Test methods
Basic Information
Standard ID:
JB/T 10402.2-2004
Standard Name: Off-grid wind turbine yaw system Part 2: Test methods
Chinese Name:
离网型风力发电机组偏航系统 第2部分：试验方法
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release2004-02-10
Date of Implementation:2004-06-01
standard classification number
Standard ICS number:Energy and Heat Transfer Engineering >> 27.180 Wind Power Generation Systems and Other
Standard Classification Number:Energy, Nuclear Technology>>Energy>>F11 Wind Energy
associated standards
Publication information
publishing house:Mechanical Industry Press
ISBN:15111.7277
Publication date:2004-05-30
other information
drafter:Jia Dajiang, Wu Shusen
Drafting unit:Inner Mongolia Guofei New Energy Co., Ltd.
Focal point unit:National Wind Machinery Standardization Committee
Proposing unit:China Machinery Industry Federation
Publishing department:National Development and Reform Commission of the People's Republic of China
Introduction to standards:
This part specifies the test conditions, test equipment, test methods and quality judgment of the yaw system of off-grid horizontal axis wind turbines. This standard is applicable to horizontal axis wind turbines with a rotor swept area of less than 40 square meters. JB/T 10402.2-2004 Off-grid wind turbine yaw system Part 2: Test method JB/T10402.2-2004 Standard download decompression password: www.bzxz.net
Some standard content:
1CS27.190
Machinery Industry Standard of the People's Republic of China
JB/T10402.2--2004
Off-grid wind turbine
Yaw system
Part 2: Test method
Yaw system of off-grld wind turbine gcncrator systemParez:Test method
2004-02-10 Issued
2004-06-01 Implementation
National Development and Reform Commission of the People's Republic of China Before issue
Normative documents
Test conditions
Test method
Instruments, tables and equipment used in the test
Test method.
Test non-
Ruisui setup sequence
Report content
If:1 104022-2074
J0T 10402.2-2G04
JT1C42 Off-grid wind turbine yaw system is divided into two parts: Part 1: Technical provisions: Part 2: Station access Part 2 is Part 4, this part is the first revision of this part. This part is based on the requirements of 1.200* Standardization of Industrial Automobile Part 1: Standard structure in level 3. This part is proposed by China Machinery Industry Federation! ! Technical part is proposed by China Wind Power Standardization Technical Committee and the Ministry of Industry and Information Technology. Drafting unit of this part: Nei Xiang Gu Guo Fei Xin Neng Co., Ltd. Drafting persons of this part: Zi Dajiang, Wu Sen: TE
1 Fan Yuan
Off-grid type wind turbine yaw system
Part 2: Test method
JHrr1U4C2.220c4
This part stipulates the test equipment, test method and quality judgment of the yaw system of off-grid wind turbine generator set
This part produces 2 normative referenced documents
The following clauses are reduced to the clauses of this part through the reference of H10402. This part is not applicable to all subsequent revisions (excluding errors or revisions) of the special support parts proposed on the date of the request. However, the latest versions of these documents may be used by researchers. For any referenced documents without a date, their most recent version shall apply to this part - General requirements for wind turbine design Www.bzxZ.net
(1119063.2 Island grid type wind turbine generator system Part 2: Test methods
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.