JB/T 7940.3-1995 Screw-on oil cup
Basic Information
Standard ID:
JB/T 7940.3-1995
Standard Name: Screw-on oil cup
Chinese Name:
旋盖式油杯
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1989-02-10
Date of Implementation:1990-01-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J21 Lubrication and Lubrication Devices
Publication information
other information
Introduction to standards:
JB/T 7940.3-1995 Screw-on oil cup JB/T7940.3-1995 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
JB/T 7940.3-1995
Screwing cap type lubricating cups
Screwing cap type lubricating cups1996-04-14 Issued
Ministry of Machinery Industry of the People's Republic of China
1996-04-14 Implementation
Mechanical Industry Standard of the People's Republic of China
Screwing cap type lubricating cups
Screwing cap type lubricating cups cups1 Subject content and scope of application
This standard specifies the types and sizes of screw-on oil cups. This standard applies to grease injection oil cups on mechanical equipment. 2. Reference standards
GB1159
Technical conditions for oil cups
3 Types and sizesWww.bzxZ.net
Oil cups are divided into two types, AB: Type A, see Figure 1, Type B, see Figure 2, and the sizes are as specified in the table below. Type A
Approved by the Ministry of Machinery Industry on April 14, 1996
JB/T7940.3—1995
Replaced GB 1154—89
Implemented on April 14, 1996
Minimum capacity
M8x×1
M24 ×1.5
Marking example
JB/T7940.31995
Minimum container 25cm', marking of type A screw-on oil cup: oil cup A25GB1154
5 Technical conditions
Technical conditions are in accordance with the provisions of GB1159.
Additional instructions:
This standard is proposed by the Ministry of Machinery and Electronics Industry. Type A
Basic dimensions
Plate limit deviation
This standard is under the jurisdiction of the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by the Science and Technology Information Institute of the Shanghai Mechanical and Electronic Industry Administration Bureau and the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry. Shenyang Oil Cup Factory participated in the drafting.
The main drafters of this standard are Chen Huajin and Wang Xiliang, 2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.