JB/T 8010.13-1999 Machine tool fixture parts and components straight plate
Basic Information
Standard ID:
JB/T 8010.13-1999
Standard Name: Machine tool fixture parts and components straight plate
Chinese Name:
机床夹具零件及部件 直压板
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8010.13-1999 This standard is a revision of JB/T 8010.13-95 "Straight Plates for Machine Tool Fixture Parts and Components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the straight plate applicable to thread specifications of M8 to M20. This standard was first issued in 1981 as GB 2187-80, first revised to GB/T 2187-91 on April 30, 1991, and adjusted to JB/T 8010.13-95 in April 1996. JB/T 8010.13-1999 Straight Plates for Machine Tool Fixture Parts and Components JB/T8010.13-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Bureau of Machinery Industry
Implementation on 2000-01-01
■Scope
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesStraight clamp plate
This standard specifies the straight clamp plate with thread specifications of M8~M20. 2 Reference standards
JB/T 8010.13—1999
Replaces JB/T8010.13—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699—1988
JB/T8044—1999
3 Dimensions
Technical conditions for high-quality carbon structural steel
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table. wwW.bzxz.Net
Approved by the State Bureau of Machinery Industry on August 6, 1999, and implemented on January 1, 2000
Nominal diameter
(thread diameter)
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T6994.2 Heat treatment: 35-40HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
JB/T8010.13—1999
Straight pressure plate with nominal diameter -8mm, L=80mm: pressure plate 8×80JB/T8010.13—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.