JB/T 6930-1993 Terminology of Environmental Protection Equipment
Basic Information
Standard ID:
JB/T 6930-1993
Standard Name: Terminology of Environmental Protection Equipment
Chinese Name:
环境保护设备 术语
Standard category:Machinery Industry Standard (JB)
state:Abolished
Date of Release1993-07-13
Date of Implementation:1994-07-01
Date of Expiration:2004-10-01
standard classification number
Standard Classification Number:Machinery>>General Machinery and Equipment>>J88 Environmental Protection Equipment
Publication information
other information
Focal point unit:Mechanical Industry Environmental Protection Technology Research Institute
Publishing department:Mechanical Industry Environmental Protection Technology Research Institute
Introduction to standards:
This standard specifies the terms and definitions of environmental protection equipment, and explains the basic characteristics and application scenarios of some equipment. This standard provides 269 terms for environmental protection equipment, which are divided into four parts according to the treatment objects: air pollution control equipment, water pollution control equipment, solid waste treatment and comprehensive utilization equipment, and noise control equipment. This standard is applicable to the preparation of environmental equipment standards, and should also be used as a reference in the preparation of the terminology part of other standards and the preparation of environmental protection professional textbooks. JB/T 6930-1993 Environmental Protection Equipment Terminology JB/T6930-1993 Standard download decompression password: www.bzxz.net
Some standard content:
Inspection Items
Inspection Level
Qualified Quality Level
Article 6.2, Article 6.3
8.3 In the above sampling plan, if the sample sizes required for various inspection items are different, the largest sample should be drawn at one time, and the small sample should be drawn in advance from the large sample before inspection.
9. Marking and Packaging
9.1 The content of the simple sand sleeve mark includes:
a. Manufacturer name;
b Product name:
c Size specification;
d Abrasive and particle size number:
e Manufacturing date or batch number.
The above marking content may not be marked on the product, but it can be marked on the packaging or provided in the form of instructions. 9.2 The packaging should be solid, reliable, and comply with the relevant regulations of the transportation department. The full text reading has ended. Downloading this article requires three 900 points
8.1 The factory or delivery inspection of the simple sand sleeve shall be carried out according to the items specified in Articles 5 and 6. 8.2 The inspection of the simple sand sleeve adopts the normal sampling plan specified in GB2828. The inspection level and qualified quality level of each inspection item shall comply with the provisions of Table 3.
Inspection items
Inspection level
Qualified quality level
Article 6.2, Article 6.3
8.3 In the above sampling plan, if the sample size required for each inspection item is different, the largest sample shall be drawn at one time, and the small sample shall be drawn in advance from the large sample before inspection.
9. Marking and packaging
9.1 The content of the simple abrasive sleeve marking includes:
a. Manufacturer name;
b Product name;
c Size specification;
d Abrasive and particle size number:Www.bzxZ.net
e Manufacturing date or batch number.
The above marking content may not be marked on the product, but it can be marked on the packaging or provided in the form of instructions. 9.2 The packaging should be solid, reliable, and comply with the relevant regulations of the transportation department.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.