title>JB/T 8009.3-1999 Round clamps for machine tool fixture parts and components - JB/T 8009.3-1999 - Chinese standardNet - bzxz.net
Home > JB > JB/T 8009.3-1999 Round clamps for machine tool fixture parts and components
JB/T 8009.3-1999 Round clamps for machine tool fixture parts and components

Basic Information

Standard ID: JB/T 8009.3-1999

Standard Name: Round clamps for machine tool fixture parts and components

Chinese Name: 机床夹具零件及部件 圆压块

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1999-08-06

Date of Implementation:2000-01-01

standard classification number

Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)

Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture

associated standards

alternative situation:JB/T 8009.3-1995 (original standard number GB/T 2173-1991)

Publication information

other information

Focal point unit:Mechanical Science Research Institute

Introduction to standards:

JB/T 8009.3-1999 JB/T 8009.3-1999 Machine tool fixture parts and components round clamp JB/T8009.3-1999 Standard download decompression password: www.bzxz.net

Some standard content:

ICS 25. 080. 01
Mechanical Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Bureau of Machinery Industry
Implementation on 2000-01-01bzxz.net
1 Scope
Mechanical Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesRound holddown
This standard specifies round holddowns with an outer diameter of 20~60mm. 2 Referenced standards
JB/T8009.3—1999
Replaces JB/T8009.3-1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699—1988 Technical conditions for high-quality carbon structural steel JB/T80441999 Technical requirements for machine tool fixture parts and components 3 Dimensions
The dimensions are shown in the following figure and table.
Dimensions of corresponding accessories
Approved by the State Machinery Industry Bureau on August 6, 1999 62
Implemented on January 1, 2000
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions shall comply with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
D=32mm round block:
Block 32JB/T8009.3—1999
JB/T8009.3-1999
Parts
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.