JB/T 8600.1-1997 This standard is a revision of ZB J54 001-87. This standard specifies the requirements and methods for the geometric accuracy inspection and working accuracy inspection of table tapping machines. This standard applies to general-purpose ordinary accuracy table tapping machines with a maximum tapping diameter of M24. JB/T 8600.1-1997 Table tapping machine accuracy inspection JB/T8600.1-1997 standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
JB/T8600.1-1997
Bench-type tapping machine
1997-08-18 Release
Precision inspection
1998-01-01 Implementation
The Mechanical Industry Standard of the People's Republic of China
JA/T8600.1-1997
Standard is for the precision of ZBE4CO1
87-type tapping machine.
The standard will be effective from the date of entry into force. The time is ZB540017. This standard was proposed by the Metal Cutting Machine Tool Standardization Technical Committee. This standard is owned by Shenyang Research Institute: This standard was drafted by Nanjing People's Machinery Industry. 1 Scope
Machinery Industry Standard of the People's Republic of China
Precision Inspection of Table-type Tapping Machines
JB/T8600.1—1997
51-87
Specifies the requirements and inspection methods for the precision inspection of table-type tapping machines. This standard is applicable to ordinary precision table-type tapping machines for one purpose with a diameter of M21. 2 Referenced Standards
The following standards contain provisions that constitute the provisions of this standard by reference in the following standards: When this standard is issued, the version shown is the version with the same meaning. All standards will be revised, and the various forces of this standard should be used to operate the seat and use the new standard. CB19781
GH/T 968-94
GB/T 1D31-95
B267-2
JB/2228-55
3-General requirementswwW.bzxz.Net
General mourning difference and matching (diameter 1~335mm) wire frequency pattern case
Table relative degree and its value
will belong to the precision control inspection and measurement of cutting machine tools
Change the diameter of the aluminum hole with twist drill
3.1 Quick month this standard insertion should be like the dirty JB267C list related provisions. Especially before the pull installation + shaft and other auxiliary parts of the dry operation temperature rise, inspection piece micro and inspection work box temperature.
3.2 Refer to the provisions of 3.1 in JR2670-83 to adjust the installation level, put a ruler on the working surface (or above), and the horizontal reading of the water level on it should not exceed 0.10/13.3 Before the inspection, the tools and inspection methods can be generally replaced, and the inspection items and requirements are arranged in the order of inspection. 3.4 When the actual micro length is different from the length specified in this standard, it should be converted according to the length that can be measured according to the provisions of 3.3.1.1 in 2670-82. When it is less than 0.0m, it is still calculated as 3.5 The "vertical" referred to in this standard refers to the self-supporting plane passing through the main shaft axis, the vertical axis and the center line of the base, longitudinal! The value number refers to the straight line through the axis and straight to the withdrawal plane. 3.6 The test items can be increased or decreased by agreement between the user and the manufacturer. The Ministry of Machinery Industry approved 170818 and implemented it in 1801-01 (No. 8600.1-1997).
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.