JB/T 10117.1-1999 Internal centering for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 10117.1-1999
Standard Name: Internal centering for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 内拨顶尖
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10117.1-1999 This standard specifies internal turning centers with Morse taper of 2 to 6. This standard was first published in 1983 as JB 3387-83 and revised for the first time in 1991 as GB/T 12878-91. JB/T 10117.1-1999 Internal turning centers for machine tool fixture parts and components JB/T10117.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
2000-01-01 Implementation
Machinery Industry Standard of the People's Republic of China
Machinery parts and units
Inside draft cntre
This standard defines the Momin cone as a 2-in-1 category. 2 Referenced standards
JB/T10117.1—1999
The texts contained in the following standards constitute the provisions of this standard by virtue of their applicability in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. B/11298: 1986 Technical conditions for steel inlays GB/T [443] Machine tools and tooling for self-adhesive circular shaped steel JErT8n44] 3 Dimensions Technical requirements for machine tool parts and components Dimensions are shown in the following figure and table.
AA Exhibition
Approved by the State Machinery Industry Bureau on August 6, 1999, 29h
2(000-01-01 implementation
4 Technical conditions bzxZ.net
4.1 Material: T8 I CBT1298 selected. JB/T10117, 1-1999
Guishi Guolv
4.2 Heat treatment: 55-GnHRC, Weiner 40-45HRC4.3 Other technical conditions in accordance with the provisions of January 14. 5 Marking
5. 1 Marking example
Mo valve tank No. 4 inner rain type:
Pre-pointed 4JB/T10117.1:-1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.