This standard is formulated for the first time. This standard specifies the test equipment, sample pretreatment, sample quantity, test steps and test report for the stacking test of large packages of dangerous goods. This standard is applicable to the stacking test of large packages of dangerous goods. This standard corresponds to the United Nations "Recommendations on the Transport of Dangerous Goods Model Regulations" and is not equivalent to it. Its relevant technical content is completely consistent with the above manual, and the standard text format has been edited according to GB/T1.1-2000. GB/T 21583-2008 Test method for stacking large packages of dangerous goods GB/T21583-2008 Standard download decompression password: www.bzxz.net
This standard is formulated for the first time. This standard specifies the test equipment, sample pretreatment, sample quantity, test steps and test report for the stacking test of large packages of dangerous goods. This standard is applicable to the stacking test of large packages of dangerous goods. This standard corresponds to the United Nations "Recommendations on the Transport of Dangerous Goods Model Regulations" and is not equivalent to it. The relevant technical contents are completely consistent with the above manuals, and the standard text format has been edited according to GB/T1.1-2000.
This standard corresponds to the United Nations "Recommendations on the Transport of Dangerous Goods Model Regulations", and the degree of consistency is not equivalent. The relevant technical contents are completely consistent with the above manuals, and the standard text format has been edited according to GB/T1.1-2000.
This standard is proposed and managed by the National Technical Committee for Standardization of Dangerous Chemicals Management (SAC/TC251).
The responsible drafting unit of this standard: Tianjin Institute of Inspection and Quarantine Science and Technology.
Participating drafting units of this standard: Jiangnan University, Sinochem Chemical Standardization Research Institute, Tianjin Entry-Exit Inspection and Quarantine Bureau.
The main drafters of this standard: Feng Zhiwei, Wang Libing, Li Xueyang, Xu Chuanlai, Wang Xiaobing, Zhao Lihua.
This standard is formulated for the first time.
GB/T4122.1 Fundamentals of packaging terminology
GB/T4857.3 Static load stacking test method for packaging and transport packages (GB/T4857.3-1992, eqvISO2234:1985)
GB19432.1 General safety regulations for inspection of large packages of dangerous goods

National Standard of the People's Republic of China
G/121583-2008
Dangerous O--Test method for stacking of large packaging
2008-04-01 Issued
General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China
2008-03-01 Implementation
C3/T 21583---208
think, girl sex is not effective, have
this lawsuit can be against the United Nations China related dangerous goods still rely on the avoidance of my villa children content and the upper fan manual complete food number, in the standard text map Wu on the connection: T12C0 did the edge of the column repair release this ball play with gold encounter dangerous chemicals reputation plastic standard elegant chemical technology home trade will ST factory use the state this standard negative spot carrier unit: Tianfa City Inspection and Quarantine Science and Technology Research Institute this standard fee unveiling unit, Hongchao University, Sinochem Chemical Standardization Ship Research Institute, Tianhu Sales People's Education Ling Inspection Glass Bureau this standard elegant waist start burial people code tide diligence, engineering measurement soldiers, Ju Xueyang, Fan Chuan rate, Fu Xiaomin, Zhao Caihua, standard avoidance for the second science court
m Fan Park
dangerous goods|| tt||Large packaging code test method
G8,21583---200awwW.bzxz.Net
This standard introduces the test equipment for large packaging code test, and the test sample number is prepared in advance. It is necessary to test the quality of this standard with a large self-test machine. 2 Normative references
The terms in the following documents are available for use in accordance with the signed terms of this standard. They are the reference documents of the period. All amendments (excluding the latest revisions) are not applicable to this standard. However, the new documents can be used before the new standard is reached. Where special requirements are noted, the latest standard should be avoided as much as possible. GE/T 1122.1 14 to import
GBTAS7.e packaging
C 19432, 0
Long inspection secret
3 terms and fixed support
GH/T 412 GB 19434
Big packaging
backagiugs
is a bay package multiple imperial war
400g or rate only draw 101 fake no mark
lined plastic r
quantity refers to male external release of people's fragrance does not constitute
tea car container
maximum permitted grace hall
rhrsirrgux perrxisilbae genns mnssB/11.31932.cq71502234
For this compensation,
Read the machine city law. The law is sensitive to more than
Simple tube Wei bag.
The quality of the whole body and its sales equipment plus the maximum allowable technical quality is applicable to all kinds of large containers)
Stacking test
Stackiag test
In the packaging of food packaging, the efficiency of placing food containers is evaluated to evaluate the static load of the packaging container and the ability of the packaging to protect the contents.
4 Test equipment
4.1 The code test equipment should be in accordance with GB/T837. 4.2 The water table should be level and the height of the support point should not exceed mm. If the concrete is single-sided, its height should be not less than 150 I
4.3 Install the feeling according to the new selection of wide opening method (method 1 or method 3 research method!, your entire building, the maintenance of the silver parts of the packaging are all the same as the sincere test in the reading test disassembly product research, the number of packing storage you use to achieve the life of the appropriate total quality of the load before the predetermined 1/21583--2008
method of the self-loading capacity of the board, the board should be able to connect the appropriate load you·test group close to The point is adjusted to the flat surface, and the flat plate is called a body. When the center of the flat plate is installed, the heat of the leather packaging parts is at least 1 inch. The board is extended to the width to verify that it can withstand the full width of the cutting path without deformation, ... up to 3, and the single board is loaded with equal height. The deep guide measures make the flat plate follow the same point and get a good end water holding, and the error caused by the paint surface is not cold. The sample is loaded on a flat plate and the sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The sample is tested on all sides. The lake body, thanks to the double-body decomposition test, will be the largest sugar in the test material waist of the mouse, the research and development of the material storage is the most complex, it is very likely to make the test results invalid. s2.3 When using multiple frequency excitation products, it should have the same material (quality, etc.) as the material inside or outside the material. 5.2.4 Unlicensed duty adds micro-effects, the overall quality requirements are met, and the effect is obtained. 2. Single fiber silver bag Mengcheng fake business code to avoid the problem of temperature control environment micro-scattering to home 2#, the following three options, the country's choice: Meng's urine environment through the obvious density of one 2 and health double 2 selection, the degree of chaos to improve the degree 2; the most source degree 3? Remember 2 I prove the magic 552: life, the manwei concept of reducing fat energy food has the main effect of short-term life energy. Matching Huihua relies on the version of the mouse Kang: I move on the violent energy gathering sea Xi lose. ||t t||5.3 Steps
5.5.1 Place the whole test package on the ground, and place the load card at the center of the test package. The load should be greater than 1cm around the package.
5.3. Then add load to the large package. The test load added to the large package should be equal to the total weight of the large package.
6 Test sample name, number, specification
Manufacturer name,
Test equipment:
Record of test results and any interesting phenomena observed during the test, test method used, test personnel signature, test unit general chapter: GB-7 21583-2008
#人#区
Yan Jiaxiang
Dangerous goods large color package QR code test liquid
G3: T 2108.-2308
China General Standard Bank Society Beihui Issue
Bei Lei Ai Xing Guang Yu Point Li Run Bei Yu Hao
W. Ww. Sot. net. ce
Tel: 6853394688517598
China Standard Hot Doing Society Chang Geng Road Printing Test, People's
Yinghua Bookstore
Seeking 833x1834 8
Instant increase of 0.5 Xue Ji 6 Hand Words
268 Year 5 Scan Number 20 Diagnosis 6 Use the First Ball City
Books, etc.: 1550 1-31830 Road 10. 09 The light is issued by our company.
New printing and binding process
Copyright
Slow and resolute will be investigated
Report phone number (010368533533
-E8S12 3/1
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.