GB/T 2856.4-1990 Die rolling guide die seat intermediate guide column lower die seat
Basic Information
Standard ID:
GB/T 2856.4-1990
Standard Name: Die rolling guide die seat intermediate guide column lower die seat
Chinese Name:
冲模滚动导向模座 中间导柱下模座
Standard category:National Standard (GB)
state:Abolished
Date of Release1990-07-23
Date of Implementation:1991-05-01
Date of Expiration:2008-10-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Chipless Processing Equipment>>25.120.30 Molding Equipment and Casting Equipment
Standard Classification Number:Machinery>>Process Equipment>>J46 Mold
Publication information
publishing house:China Standards Press
other information
Release date:1981-12-29
Review date:2004-10-14
Drafting unit:Guilin Electrical Research Institute
Focal point unit:National Technical Committee for Mould Standardization
Publishing department:National Standardization Administration
competent authority:National Standardization Administration
Introduction to standards:
GB/T 2856.4-1990 Punch die rolling guide die seat intermediate guide column lower die seat GB/T2856.4-1990 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of ChinabZxz.net
Die rolling guide die set
Intermediate guide pillar lower die set
Holder for ball slide die sets for press toolsDle holder for center pillar setsSubject content and scope of application
GB/T 2856.490
Replaces GB2856.4-81
This standard specifies the materials, technical conditions, structural types and specifications of the intermediate guide pillar lower die set of the die rolling guide die set. This standard applies to the die rolling guide die set. 2 Reference standards
GB/T12446 Technical conditions for die set parts GB9439
Grey cast iron parts
8 Materials, technical conditions, structural types and specifications of die sets8.1 Material: HT 200 GB 9439.
Aging treatment twice.
8.2 Technical conditions are in accordance with the provisions of GB/T1
12446.
Structural types and specifications are shown in the figure and table.
Approved by the State Administration of Technical Supervision on July 23, 199066
Implementation on May 1, 1991
3.4 Marking example
GB/T2856.4 -90
Die perimeter L=200mm,
B=160mm, thickness H=55mm, intermediate guide column lower die seat: lower die seat 200×160×55GB/T2856.4BB
Die perimeter
GB/T2856.4—-90
1303640
Note: The shape and plane dimensions of the platen are determined by the manufacturer. 50
Additional Notes:
This standard is proposed by the Ministry of Machinery and Electronics Industry of the People's Republic of China. Basic
d,(R7)
This standard is under the jurisdiction of the National Technical Committee for Mold Standardization. This standard was drafted by the Mold Branch of Guilin Electric Science Research Institute of the Ministry of Machinery and Electronics Industry. The main drafters of this standard are Wang Huayi and Qin Guangwei. This standard is entrusted to the Mold Branch of Guilin Electric Science Research Institute of the Ministry of Machinery and Electronics Industry for interpretation. 68
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.