JB/T 10126.1-1999 Transition plates for three-jaw chucks for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 10126.1-1999
Standard Name: Transition plates for three-jaw chucks for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 三爪卡盘用过渡盘
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10126.1-1999 This standard specifies the transition plate that is applicable to the C-type and D-type connection methods in GB/T 5900.1~5900.3-1986 "Interchangeability Dimensions of Flange-type Spindle Ends and Faceplates for Machine Tools" and connected to GB/4346~4347-1984 "Three-jaw Self-centering Chuck". This standard was first published in 1983 as JB 3400-83 and revised for the first time in 1991 as GB/T 12891-91. JB/T 10126.1-1999 Transition plate for three-jaw chuck of machine tool fixture parts and components JB/T10126.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixtures
The pirts add nnits af jigs and fixtoresTrauisitional plnte for 3-jaw chuckJB/T14126.1-1999
This standard specifies the transition plates applicable to the C-type and D-type connection methods in GB5900.1-5900.3 and connected with GB/T4346~4347.
2 Referenced Standards
The following standards contain the following referenced texts: The provisions of this standard are established by reference in this standard. The versions shown are valid at the time of publication of this standard. All the above standards are subject to revision. The parties using this standard should consider the applicability of the latest technical versions of the following standards. GB5900.1-5900.3—1986 Machine tool flange type semi-contact end and disc conversion dimensions (B.4346-4347—1984
3 Dimensions
Three-pipe self-centering chuckWww.bzxZ.net
Dimensional drawing!, as shown in Figure 2 and Table 1. Table 2
Approved by the State Machinery Industry Bureau in August 1999
Implemented in January 2001
Axle Department of the Ministry of Industry and Information Technology
Basic size Vibration limit difference BA Energy Special JB/T10126.1—1999 Spindle end code Main size: 4 Marking Plate negative offset Basic small size Research limit 4. Marking example: JB/T10126.1—E999 +U Qu3
139714
The spindle end code is 6, D-250mm. The C-type three-jaw chuck with reduced relay is used for the transition plate: C6×250/T10126.1—1999. The spindle end code is 6, D-250mm. The D-type one-jaw chuck with the connection method is used for the transition plate: D6×250JBT10126.119994on
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.