JB/T 9159.6-1999 JB/T 9159.6-1999 Single-axis longitudinal cutting automatic lathe auxiliary tool die clamp C-type dimensions JB/T9159.6-1999 Standard download decompression password: www.bzxz.net

[C25.080,01bzxZ.net
Machinery Industry Standard of the People's Republic of China
JB/T9159.1~~9159.11—1999
Accessories of single spindle automatic screwmachines with sliding headstock
Published on 1999-05-20
National Machinery Industry Bureau
Implemented on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Accessories of single spindle automatic screwmachines with sliding headstock
Type C die sleeve
Accessories of single spindle automatic sercwalachinrswilhslidingbeadstoc-DieholdertypeCDimenskons
This standard specifies the type and size of the die for single-piece longitudinal cutting white motor vehicle. 2 Referenced standards
JB/T9159.6-1999
2H157(6
The following standards contain provisions that constitute the provisions of this standard by citing them in this standard. When this standard is called, the version shown is valid. All parts of the standard are revised: All parties using this standard shall consider the possibility of using the latest version of the following standard products. GB/970. 1-4 Toilet lever type and size
Type and size
Type and size are as shown in the following figure and table. Approved by the State Machinery Industry Bureau on May 20, 1999 and implemented on January 1, 2000
Basic size
4 Marking
Marking example:
Limit difference H11
JB/T9159.6-1999
Tooth specification
30mm plate and negative C type mark:
Jacket C30JB/T9159.6—1999
Applicable to accumulation bed
CM1116
CM1120
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.