GB/T 2856.1-1990 Die rolling guide die seat diagonal guide column upper die seat
Basic Information
Standard ID:
GB/T 2856.1-1990
Standard Name: Die rolling guide die seat diagonal guide column upper die seat
Chinese Name:
冲模滚动导向模座 对角导柱上模座
Standard category:National Standard (GB)
state:Abolished
Date of Release1990-07-23
Date of Implementation:1991-05-01
Date of Expiration:2008-10-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Chipless Processing Equipment>>25.120.30 Molding Equipment and Casting Equipment
Standard Classification Number:Machinery>>Process Equipment>>J46 Mold
Publication information
publishing house:China Standards Press
Publication date:1991-05-01
other information
Release date:1981-12-29
Review date:2004-10-14
Drafting unit:Guilin Electrical Research Institute
Focal point unit:National Technical Committee for Mould Standardization
Publishing department:National Standardization Administration
competent authority:National Standardization Administration
Introduction to standards:
GB/T 2856.1-1990 Die rolling guide die seat diagonal guide pillar upper die seat GB/T2856.1-1990 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of ChinabzxZ.net
Punch rolling guide die sets
Diagonal guide pillar upper die sets
Holder for ball slide die sets for press toolsPunch holder for diagonal pillar setsSubject content and scope of application
GB/T 2856 .1 --90
Replaces GB 2856.1—81
This standard specifies the materials, technical conditions, structural types and specifications of the diagonal guide pillar upper die sets of the punch rolling guide die setsThis standard applies to the punch rolling guide die sets. Reference standards
GB/T12446Technical conditions for die sets partsGB9439Grey cast iron parts
3Material, technical conditions, structural types and specifications of die sets3.1 Material: HT 200 GB 9439.
Aging treatment twice.
3.2Technical conditions shall be in accordance with the provisions of GB/T12446. 3.3 The structural type and specifications are shown in the table.
Approved by the State Administration of Technical Supervision in 1990-0723
Implemented in 1991-05-01
GB/T 2856.190
3.4 Marking example:
Die perimeter L=200mm, B=160mm, thickness H=45mm, diagonal guide pillar upper die seat: upper die seat 200×160×45GB/T2856.158
Die perimeter
Additional instructions:
2856.1—90
This standard is proposed by the Ministry of Machinery and Electronics Industry of the People's Republic of China. This standard is under the jurisdiction of the National Technical Committee for Mold Standardization. Limit
This standard is drafted by the Mold Branch of Guilin Electric Science Research Institute of the Ministry of Machinery and Electronics Industry. The main drafters of this standard are Wang Huachang and Qin Guangwei. Limit
This standard is entrusted to the Mold Branch of Guilin Electrical Science Research Institute of the Ministry of Machinery and Electronics Industry to interpret. t
M6 -6 H
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.