JB/T 10124-1999 Machine tool fixture parts and component dials
Basic Information
Standard ID:
JB/T 10124-1999
Standard Name: Machine tool fixture parts and component dials
Chinese Name:
机床夹具零件及部件 拨盘
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10124-1999 This standard specifies the dials for the C-type and D-type connection methods in GB/T 5900.1~5900.3-1986 "Interchangeability Dimensions of Flange-type Spindle Ends and Faceplates for Machine Tools". This standard was first published in 1983 as JB 3398-83 and revised for the second time in 1991 as GB/T 12889-91. JB/T 10124-1999 Machine Tool Fixture Parts and Component Dials JB/T10124-1999 Standard Download Decompression Password: www.bzxz.net
Some standard content:
IC5 28.060.41
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Bureau of Machinery Industry
Implementation on 2000-01-01
1 Scope
Machinery Industry Standard of the People's Republic of China
The parts aud units orjlgs and fixturesDriving plate
This standard specifies the applicable C-type and D-type connection methods in sub-G3 rows 5900.1~5900.3. 2 Referenced standards
JBrE10124-1999
The provisions contained in the following standards shall become the provisions of this standard through reference in this standard. The versions shown are valid at the time of publication. All standards will be revised. All parties using this standard should explore the possibility of using the latest version of the underlined standard. GB/T59QQ.1-5900.3-1986 Interchangeability of main and auxiliary ends and faceplates of machine tools flange type 3 feet 4
Dimensions are shown in Figure 1, Figure 2, and Table 2. C
Approved by the State Machinery Industry Bureau on August 6, 1999 318
Implementation on January 1, 2000
Shaft travel code
Basic wood size
Over-limit difference
[R/T10124-1999
62:565
235 t)
Main sugar code
Basic size bzxz.net
4 Mark
General limit partial aromatic
4.! Marking example:
FH10124-1999
Spindle end code is 5, D~200mm, C-type connection method, dial C5×200JB10124—1999
Spindle end code is 6, 0=250 mm, D-type connection method, dial D6×250JB/T10124—1g
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.