This standard specifies the dimensions and tolerances of 1:24 conical holes for spiral bevel gear milling cutters. This standard applies to conical holes for spiral bevel gear milling cutters with a taper of 1:24 and a taper length of 6 to 40 mm. JB/T 8345-1996 Dimensions and tolerances of 1:24 conical holes for spiral bevel gear milling cutters JB/T8345-1996 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
JB/T 8345-96
Spiral Bevel Gear Milling Cutter 1:24 Taper HolebzxZ.net
Dimensions and Tolerances
Published on April 11, 1996
Ministry of Machinery Industry of the People's Republic of China
Implementation on November 1, 1996
Mechanical Industry Standard of the People's Republic of China
Spiral Bevel Gear Milling Cutter 1:24 Taper Hole
Dimensions and Tolerances
1 Main Content and Scope of Application
Supplementary Standard specifies the size and tolerance of spiral bevel gear milling cutter 1:24 taper hole. JH/T 8345-96
This standard applies! Cone seat 1.24 The chain length is connected to the arc step bevel gear of 6~40mm. The back taper is used for washing the moon. 2 Reference standards
Chain and angle system
GH11354 Circular tolerance
JB5563
Metal corrosion cutting machine tool cone surface comprehensive color method inspection and evaluation 3 Cone hole size and tolerance
Network standard hole size and tolerance related terms and definitions, symbols, codes according to the relevant provisions of GB15? and GB11334, the cone diameter tolerance, the basic back auxiliary diameter (chain large end diameter) is the basic size, The basic size and limit deviation values ​​are shown in Table 3.2. The round angle tolerance of the cone is shown in Figure 3.35, which is the same as the shape tolerance T. The cone diameter tolerance T is uniformly distributed in the cone diameter tolerance T, and the determined circle tolerance band is 3.35. The angle tolerance AT is expressed by the angle value, and the single and double minus limit difference is given. The basic single angle and over-limit deviation value of the chain angle are shown in Figure 1. The diameter of the cone is approved by the Ministry of Machinery Industry on April 11, 1906. +t, co
1: 24 =
National cone basic angle.
2\23'-5.
Extreme matching difference
199610-01 implementation
JB/Gate 8345-96
Inspection of 1124 round cans of strong tooth gear milling cutter (supplement)
When the large end diameter of the A1 face cone is inspected by a plug gauge, the diameter tolerance is converted into an end face comparison and inspected with a feeler gauge. The round angle error and shape error of the 42-meter round cone are inspected by color coating with a comprehensive rate gauge. The inspection method should comply with the relevant provisions of JB5563, and the contact rate should not be less than.
Additional explanation:
This standard is proposed by the National Technical Committee for Equipment Standardization. This standard is under the jurisdiction of Chengdu Tool Research Institute. This standard was issued by Harbin First Tool Institute, China Institute of Metrology and other units. Cold
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.