GB 4133-1984 Types and dimensions of forced transmission of Morse cones
Basic Information
Standard ID:
GB 4133-1984
Standard Name: Types and dimensions of forced transmission of Morse cones
Chinese Name:
莫氏圆锥的强制传动型式及尺寸
Standard category:National Standard (GB)
state:in force
Date of Release1984-01-18
Date of Implementation:1984-10-01
standard classification number
Standard ICS number:Mechanical systems and general parts >> 21.200 Gears and gear transmissions
Standard Classification Number:Machinery>>General Machinery>>J04 Basic Standards and General Methods
associated standards
Procurement status:=ISO 5413-76
Publication information
publishing house:China Standards Press
Publication date:1984-10-01
other information
Release date:1984-01-18
Review date:2004-10-14
Drafting unit:Chongqing Cylindrical Gear Machine Tool Research Institute
Focal point unit:National Technical Committee for Metal Cutting Machine Tools Standardization
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
This standard is applicable to forced transmission Morse internal cone and Morse external cone. This standard is equivalent to ISO 5413-1976 (E) "Machine tools - Forced transmission of Morse cone". GB 4133-1984 Forced transmission type and size of Morse cone GB4133-1984 Standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
The type and dimenslons for positive drive of Morse tapersThis standard applies to the following types of transmission: Morse inner taper and Morse outer taperThis standard is equivalent to IS054131976 (E) "Machine tools - Morse chain positive drive"Structural type and size:
Morse chain
Morse pressure
Marking example:
No. 5 positive drive Morse taper:
Morse taper No. 5GB4133-84
Published by the National Bureau of Standards on January 18, 1984
UDC621.9:621.
88-181
GB 4133-84Www.bzxZ.net
ISO5413-1976
1984-10-01 implementation
Additional remarks:
GB 4133-84
This standard is proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of Chongqing Cylindrical Gear Machine Tool Research Institute. Chongqing Cylindrical Gear Machine Tool Research Institute is responsible for drafting this standard. The nominal size of the cutter is the maximum temporary filling of the tube, and only the outer side is allowed.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.