title>JB/T 3411.69-1999 Dimensions of taper shank tools with guide extension sleeves - JB/T 3411.69-1999 - Chinese standardNet - bzxz.net
Home > JB > JB/T 3411.69-1999 Dimensions of taper shank tools with guide extension sleeves
JB/T 3411.69-1999 Dimensions of taper shank tools with guide extension sleeves

Basic Information

Standard ID: JB/T 3411.69-1999

Standard Name: Dimensions of taper shank tools with guide extension sleeves

Chinese Name: 锥柄工具带导向接长套 尺寸

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1999-05-20

Date of Implementation:2000-01-01

standard classification number

Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools

Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories

associated standards

alternative situation:JB 3479-1983

Publication information

other information

Focal point unit:Mechanical Science Research Institute

Publishing department:Mechanical Science Research Institute

Introduction to standards:

JB/T3411.69-1999 This standard is a revision of JB 3479-83 "Dimensions of Taper Shank Tool with Guide Extension Sleeve". Only the following points were modified during the revision, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Relevant reference standards and related content; - Thread drawing method. This standard specifies the type and size of tapered shank tool with guide extension sleeve. JB/T 3411.69-1999 Dimensions of Taper Shank Tool with Guide Extension Sleeve JB/T3411.69-1999 Standard download decompression password: www.bzxz.net

Some standard content:

IC.5 25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T3411.67~3411.82-19
Drilling machine accessories
Accessories of drilling machines1999-05-20 Issued
National Machinery Industry Bureau
2000-01-1 Implementation
Machinery Industry Standard of the People's Republic of China
Taper shank tool with guide extension sleeve
Extension busliwitli auide for taper shank tnniDimensiuns
do not limit the length of the model and size, 2 reference standard
JH/T:341I.69-199
list of machine light will be accepted by the text, through the reference in the standard dynamic degree of the blank you note the clause, the law only blue when the elimination, the excitement and price shown. All standards are revised, the use of this standard should explore the possibility of using the following standards, GB443--H
3411.83-
3 type cloth size
machine Qing and the right book door to be able to
break the state urging the knife bar
type and! Next, the chart will be taken and determined
National Machine Plate Industry Week 1999-(5-20 approved 2000-01-01 implementation
JRT 34II.69—1999
Specification deviation?
-G 025
0 050
JB/3411.69-1999
Table (end)
Relatively limited cycle benefit
This long hospital number is six small according to T3411.83-1S% required table 4 heat setting. Make a step system or do not make a record system, F design small set 2 degrees silver and meter drawing dimension size and degree GB1443 as the original 3 as needed in the outer 1 increase in continental oil tip,bzxZ.net
4 mark
Mark example:
Outer shop is point 1 net sales 5, inner chain is civil measurement shop 4, =630mm shop book two with guide connection change: extension 5-4610/1411.69--1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.