HG/T 2129.19-1991 Flange type right angle equal diameter tees for chemical equipment parts made of acid-resistant phenolic plastics
Basic Information
Standard ID:
HG/T 2129.19-1991
Standard Name: Flange type right angle equal diameter tees for chemical equipment parts made of acid-resistant phenolic plastics
Chinese Name:
耐酸酚醛塑料制化工设备零部件 凸缘式直角等径三通
Standard category:Chemical industry standards (HG)
state:in force
Date of Release1991-08-19
Date of Implementation:1992-01-01
standard classification number
Standard ICS number:Chemical Technology>>Chemical Equipment>>71.120.99 Other Chemical Equipment
Standard Classification Number:Chemical Industry>>Chemical Machinery and Equipment>>G91 Chemical Machinery and Equipment Parts
Publication information
other information
Introduction to standards:
HG/T 2129.19-1991 Acid-resistant phenolic plastics for chemical equipment parts Flange type right angle equal diameter tees HG/T2129.19-1991 Standard download decompression password: www.bzxz.net
Some standard content:
Scope of application
Chemical Industry Standard of the People's Republic of China
Flanged right-angle equal-diameter tees made of acid-resistant phenolic plastic chemical equipment parts
HG/T2129.19-91
This standard applies to flanged right-angle equal-diameter tees made of acid-resistant phenolic plastic with an allowable temperature of -30C to 130℃ and an allowable pressure as specified in the table below.
2 Reference standards
HG/T2128 Technical conditions for chemical equipment, pipes and fittings made of acid-resistant phenolic plastic 3 Types and basic dimensions
Types and basic dimensions are as specified in the figure and table below, DN
A-part magnification cabinet
Note: corner not specified r>3mm
Ministry of Chemical Industry of the People's Republic of China "91-08-1 approved 1992-01-01 implementation
Nominal diameterbZxz.net
HG/T2129.19-91
4 Quality inspection, packaging, storage and transportation of raw materials and products 9
The quality inspection, packaging, storage and transportation of raw materials and products shall comply with the provisions of HG/T2128 5 Marking example
Allowable pressure with temperature
MPa(kgf/cm
0. 40 (4)
0.15 (1.5)
0.13 (1.3)
Acid-resistant phenolic plastic flange type right angle equal diameter tee with nominal diameter DN=32mm, its marking symbol is: DN32HG/T2129.19-91
Additional instructions:
This standard is proposed by China National Chemical Equipment Corporation and is under the jurisdiction of the National Technical Committee for Standardization of Non-metallic Chemical Equipment. This standard was drafted by Chengdu Chemical Research and Design Institute. The main drafters of this standard are He Jiabing and He Jin.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.