title>GB/T 5634.2-1985 Flared combined right angle tee pipe fitting - GB/T 5634.2-1985 - Chinese standardNet - bzxz.net
Home > GB > GB/T 5634.2-1985 Flared combined right angle tee pipe fitting
GB/T 5634.2-1985 Flared combined right angle tee pipe fitting

Basic Information

Standard ID: GB/T 5634.2-1985

Standard Name: Flared combined right angle tee pipe fitting

Chinese Name: 扩口式组合直角三通管接头体

Standard category:National Standard (GB)

state:Abolished

Date of Release1985-01-01

Date of Implementation:1986-09-01

Date of Expiration:2008-11-01

standard classification number

Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts

Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories

associated standards

alternative situation:Replaced by GB/T 5634-2008

Publication information

other information

Release date:1985-11-25

Review date:2004-10-14

Drafting unit:Standardization Institute of the Ministry of Machinery Industry

Focal point unit:National Technical Committee for Standardization of Pipe Accessories

Publishing department:China Machinery Industry Federation

competent authority:China Machinery Industry Federation

Introduction to standards:

GB/T 5634.2-1985 Flared combined right angle tee pipe joint body GB/T5634.2-1985 standard download decompression password: www.bzxz.net

Some standard content:

National Standard of the People's Republic of China
Flared type tube fittings-
Swivel run tee-Body
This standard applies to flared type tube fittings for use in pipeline systems with oil and gas as the medium. Marking example:
Outer diameter of pipe D. 10mm flared combination right angle tee pipe fitting body: Fitting body 10GB5634.2-85
National Bureau of Standards 1985-11-25 issued
UDC 621.643.4
GB5634.2-85
1986-09-01 implementation
GB5634.2-85bzxZ.net
S°8 yuan
S't×zW
×91
S't×W
[×o[w
GB 5634.2-85
Technical conditions are in accordance with the provisions of GB5653-85 "Technical Conditions for Flared Pipe Fittings".
This standard is proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of the Standardization Research Institute of the Ministry of Machinery Industry. This standard was initiated by the Standardization and Chemical Research Institute of the Ministry of Machinery Industry, Shanghai Hydraulic Parts Factory, Changchun Automobile Research Institute, and Shanghai Hydraulics and Pneumatics Research Institute. The main drafters of this standard are You Lusheng, Li Ning, and Zhang Qianlong.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.