JB/T 8028.1-1999 Low legs for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 8028.1-1999
Standard Name: Low legs for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 低支脚
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 8028.1-1999 JB/T 8028.1-1999 Machine tool fixture parts and components Low support feet JB/T8028.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Mechanical Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
Mechanical Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesShort legs
This standard specifies the short legs with thread specifications of M4~M20. 2
Cited Standards
JB/T 8028.1-1999
Replaces JB/T8028.1-1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699—1988
Technical Conditions for High-quality Carbon Structural Steel
JB/T 8044--1999
3 Dimensions
Technical Requirements for Machine Tool Fixture Parts and Components
The dimensions are shown in the following figure and table.
Dimensions of accessories
Approved by the State Bureau of Machinery Industry on August 6, 1999, 202
Implemented on January 1, 2000
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 40~45HRC.
4.3 Other technical conditions in accordance with the provisions of JB8044. 5 Marking
5.1 Marking example:
Low support leg with d=M8, H=20mm:
JB/T8028.1—1999
Support leg M8×20JB/T8028.1—1999bzxz.net
Basic dimensions
Limit deviation
Accessories
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.