title>JB/T 9980-1999 Inertia vibrating table types and basic parameters - JB/T 9980-1999 - Chinese standardNet - bzxz.net
Home > JB > JB/T 9980-1999 Inertia vibrating table types and basic parameters
JB/T 9980-1999 Inertia vibrating table types and basic parameters

Basic Information

Standard ID: JB/T 9980-1999

Standard Name: Inertia vibrating table types and basic parameters

Chinese Name: 惯性振实台 型式与基本参数

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1999-05-14

Date of Implementation:2000-01-01

standard classification number

Standard ICS number:Metallurgy>>77.180 Metallurgical Equipment

Standard Classification Number:Machinery>>General Processing Machinery and Equipment>>J61 Casting Equipment

associated standards

alternative situation:ZB J61003-1988

Publication information

other information

Focal point unit:National Foundry Machinery Standardization Committee

Publishing department:National Foundry Machinery Standardization Technical Committee

Introduction to standards:

JB/T 9980-1999 This standard is a revision of ZB J61 003-88 "Inertia vibrating table types and basic parameters". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the types and basic parameters of inertia vibrating tables. This standard is applicable to inertia vibrating tables for compacting resin self-hardening sand molds (cores) in foundries. This standard was first issued in February 1988. JB/T 9980-1999 Inertia vibrating table types and basic parameters JB/T9980-1999 standard download decompression password: www.bzxz.net

Some standard content:

IGS 77.180
Machinery Industry Standard of the People's Republic of China
JB/T9980-1999
Inertial Vibrating Table
1999-05-14 Issue
Type and Basic Parameters
200-01 Implementationwww.bzxz.net
National Bureau of Machinery Industry
JB.T998D-1999
This standard is a revision of ZBJ6103-88 "Inertial Vibrating Table Type and Basic Parameters". Only the relevant provisions have been revised, and the technical content has not changed. This standard replaces ZBJ61003-88 from the date of implementation. The standard is drafted and approved by the National Foundry Machinery Standardization Technical Conference. The responsible drafting unit of this standard is: Jinan Foundry Hip Pressure Vibrating Recovery Research Institute. This standard was first issued in February 19.
Machinery Industry Standard of the People's Republic of China
Inertia Vibrating Table
Types and Basic Parameters
This standard defines the types and basic technical parameters of inertia vibrating tables. This standard applies to inertia vibrating tables used in manufacturing workshops to compact resin-hardened sand molds (cores). Types
There are two types of inertia vibrating tables: one-point frame type (see Figure 1)
straight-center fixed type
strip-feed type (see Figure 2)
3 basic integers
3.1 The main plug number is the rated load, in kN. The rated load refers to the load of the workbench. Total weight of process equipment and molding sand, 3.2 Basic sensitivity should comply with the provisions of Table 1,
National Machinery Industry Exhibition 1999-05-14 approved JB.T9980-1999
Generation 26100388
2000-01-01 implementation
Name of the performance
Determined load
Table size
Table and lifting height
Maximum basis, force
Synchronous transfer
tiraia
1500 or 3000
316.[0×2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.