JB/T 8032.1-1999 Flat feeler gauges for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 8032.1-1999
Standard Name: Flat feeler gauges for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 对刀平塞尺
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 8032.1-1999 JB/T 8032.1-1999 Machine tool fixture parts and components flat feeler gauge JB/T8032.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of ChinaWww.bzxZ.net
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Bureau of Machinery Industry
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixturesFlat feeler for tool alignment
The parts and units of jigs and fixturesFlat feeler for tool alignmentThis standard specifies the flat feeler for tool alignment with a specification of 1~5mm. Referenced Standards
JB/T 8032.1—1999
Replaces JB/T8032.1—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T12981986 Technical conditions for carbon cable tool steel JB/T8044—1999
3 Dimensions
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 220
Implementation on January 1, 2000
4 Technical conditions
Basic dimensions
4.1 Material: T8 in accordance with the provisions of GB/T1298. 4.2 Heat treatment: 55~60HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 marking
Marking example:
H=5mm tool setting ruler:
feeler gauge 5JB/T8032.1—1999
JB/T8032.1-1999
limit deviation h8
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.