JB/T 8010.5-1999 Machine tool fixture parts and components Moving wide head clamp
Basic Information
Standard ID:
JB/T 8010.5-1999
Standard Name: Machine tool fixture parts and components Moving wide head clamp
Chinese Name:
机床夹具零件及部件 移动宽头压板
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8010.5-1999 This standard is a revision of JB/T 8010.5-95 "Mobile wide head clamps for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content was not changed. This standard specifies mobile wide head clamps applicable to thread specifications of M4 to M24. This standard was first issued in 1981 as GB 2179-80, first revised to GB/T 2179-91 on April 30, 1991, and adjusted to JB/T 8010.5-95 in April 1996. JB/T 8010.5-1999 Mobile wide head clamps for machine tool fixture parts and components JB/T8010.5-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Published
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesMoving broad head ciampplate
This standard specifies the moving broad head ciampplate applicable to thread specifications of M8~M24. 2 Reference standards
JB/T8010.51999
Replaces JB/T8010.5--1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699-1988 Technical conditions for high-quality carbon structural steel JB/T8044-1999
3 Dimensions
Technical requirements for machine tool parts and components
The dimensions are shown in the following figure and table.
Approved by the State Bureau of Machinery Industry on August 6, 1999, and implemented on January 1, 2000
Nominal diameter
(thread diameter)
4 Technical conditions
Material: 45 steel in accordance with the provisions of GB/T699.
4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 Markingwww.bzxz.net
5.1 Marking example:
JB/T8010.5-1999
A-type mobile wide head pressure plate with nominal diameter = 10mm and L = 100mm: pressure plate A10×100JB/T8010.5—199978
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.