JB/T 3411.10-1999 Dimensions of square tool holder
Basic Information
Standard ID:
JB/T 3411.10-1999
Standard Name: Dimensions of square tool holder
Chinese Name:
方刀杆夹 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 3411.10-1999 This standard is a revision of JB 3420-83 "Square Tool Bar Clamp Dimensions". Only the following points were modified during the revision, and the main technical content remained unchanged. ——Writing format; ——Standard plus English name; ——Related reference standards and related content; ——Thread drawing method. This standard specifies the type and size of square tool bar clamps. This standard is applicable to square tool bar clamps for clamping JB/T 3411.7-1999 "45° Square Tool Bar Dimensions for Turning Internal Holes" and JB/T 3411.6-1999 "90° Square Tool Bar Dimensions for Turning Internal Holes". JB/T 3411.10-1999 Square Tool Bar Clamp Dimensions JB/T3411.10-1999 Standard download decompression password: www.bzxz.net
Some standard content:
[CS25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T 3411.1-3411.16—1999
Accessories ofgeneral purpose parallel lathes1999-05-20Promulgated
State Bureau of Machinery Industry
2000-01-01Implementation
·Scope
Machinery Industry Standard of the People's Republic of China
Clamp foraquarel bolderDimensionsThis standard specifies the types and dimensions of square bars. JB/T 3411.10-1999
Daimang IB3420-83
Small standard applies to square tool bars with JB/T3411.7-199945 inner hole square tool bar, size and JB/T3411.61990 inner hole square tool bar size". 2 Type and size
Type and size follow the lower limit and table. i
Marking example:
H16mm tool bar clamp:
Square tool bar clamp 16JB/T3411.101999
National Machinery Industry Bureau 1999-05-20 approved
Applicable deep modelbzxZ.net
C-500630
[-U0U, C-1250
2000-01-01Implementation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.