JB/T 8010.15-1999 Machine tool fixture parts and components - Rotary clamps
Basic Information
Standard ID:
JB/T 8010.15-1999
Standard Name: Machine tool fixture parts and components - Rotary clamps
Chinese Name:
机床夹具零件及部件 回转压板
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 8010.15-1999 JB/T 8010.15-1999 Machine tool fixture parts and components Rotary clamp JB/T8010.15-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Published
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesRotary clamp plate
This standard specifies the rotary clamp plate with thread specifications of M5~M16. 2 Referenced standards
JB/T8010.15-1999
Replaces JB/T 8010.15—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards are subject to revision, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T 699—1988
GB/T830—1988
JB/T8044—1999
3 Dimensions
Technical conditions for high-quality carbon structural steel
Slotted cylindrical head axial screws
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999, implemented on January 1, 2000
Basic dimensions
Limit deviation h11
Basic dimensions
Limit deviation H11
Matching screws GB/T830
1) Designed by yourself according to the needs of use. bzxZ.net
JB/T8010.15—1999
M8×10
M12 xt6\
M16×20m
Technical conditions
4.1Material: 45 steel according to the provisions of GB/T699. 4.2Heat treatment: 35~40HRC.
4.3Other technical conditions shall be in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
JB/T8010.15—1999
d-M10, -50mm A-type rotary pressure plate:
Pressing plate AM10×50JB/T8010.15—1999100
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.