GB/T 5632.1-1985 Flared combined right angle pipe joint
Basic Information
Standard ID:
GB/T 5632.1-1985
Standard Name: Flared combined right angle pipe joint
Chinese Name:
扩口式组合直角管接头
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:1986-09-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1986-09-01
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
GB/T 5632.1-1985 Flared combined right angle pipe joint GB/T5632.1-1985 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Flared type tube fittings-
Swivel elbow-Assembly
This standard is applicable to the system of gas-to-medium bypass GR 646-85
GB 5647.-85
Marking example:
Flared type tube fittings-
Swivel elbow-Assembly
Flared type tube fittings-
Swivel elbow-Assembly
This standard is applicable to the system of gas-to-medium bypass GR 646-85
GB 5647.-85
Marking example:
Flared type tube fittings with an outer diameter D of 10mm: Pipe fitting 10GB5632.1--85
Promulgated by the National Bureau of Standards on November 25, 1985
UDC 621.643.4
GB5632.1-85
Implementation on September 1, 1986bzxZ.net
Tube outer diameter
M12 × 1.5
M14 × 1.5
M16 × 1.5
M18 × 1. 5
M22 × 1. 5
M24 × 1. 5
M27 × 1. 5
M31 × 2
M33 × 2
M36 × 2
M39×2
M42×2
M45×2
GB5632185
Yi string (steel)
kg/10u piece
Note: The opposite side dimension is S. The connection between the lock nut and the joint body is determined by the selection method. The dimensions shown in the figure shall comply with the provisions of the number, and the nut shall be able to rotate freely on the joint body. The technical conditions shall be in accordance with the provisions of GB5653-85 "Technical Conditions for Expanded Pipe Joints". Additional remarks:
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and drafted by the Standardization Research Institute of the Ministry of Machinery Industry.
This standard was drafted by the Standardization Research Institute of the Ministry of Machinery Industry, Haiye Accessories Factory, Changchun Automobile Research Institute, and Haiye Power Research Institute. The main drafters of this standard are Hu Lu, Li Yuyu, and Zhang Qianlong.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.