JB/T 3411.117-1999 7:24 Dimensions of end milling cutter shanks with taper shanks and end keys
Basic Information
Standard ID:
JB/T 3411.117-1999
Standard Name: 7:24 Dimensions of end milling cutter shanks with taper shanks and end keys
Chinese Name:
7：24 锥柄带端键端铣刀杆 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
associated standards
alternative situation:JB 3528-1983
Procurement status:neq ISO 3937:1985
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 3411.117-1999 This standard is a revision of JB 3528-83 "7:24 taper shank with end key end milling cutter bar dimensions". During the revision, only the following points were modified, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Relevant reference standards and related contents; - Thread drawing method. This standard is not equivalent to ISO 3937:1985 "Key end drive milling cutter bar dimensions" This standard specifies the type and dimensions of 7:24 taper shank with end key end milling cutter bar. JB/T 3411.117-1999 7:24 taper shank with end key end milling cutter bar dimensions JB/T3411.117-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 25.00.01
Mechanical Industry Standard of the People's Republic of China
IB/T 3411.101-3411.127—1999 Accessories for milling machines
Accessories afmilling maclhincs1999-05-2U Issued
National Machinery Industry Bureau
2000-01-01 Implementation
Mechanical Industry Standard of the People's Republic of China
: 24 taper shankand with end key End anilling arbnr with 7 : 24 taper shankand with end key keyninensinnx
This standard specifies: 24 taper end and end selection tool bar type and ~ 2 reference standards
JB/T3411.117-1999
B35283Www.bzxZ.net
The texts contained in the underlined standards are the provisions of foreign standards through the use of ice standards. When this standard is published, the capital stock indicated is valid. New standards will be considered, and the parties using the standard should discuss the reliability of the latest version of the following standard: GBT3937.3-19837: 24 taper connection 1 handle 3 type and size
Type and size are as follows: al
Note: The ear body of the end key is not determined by the internal design, approved by the National Machinery Industry Bureau on May 20, 1999.34
2000-01-1 implementation
Basic limit deviation
JB/T34I1.11T-1999
Limited deviation type
Note: 7:24 push back the ruler and promote the GD3837.3 beat 1 mark
Marking example:
Limit deviation ticket
7:24 example dimension 4U number, d-32mm 7:24 who handle with end build end jump knife rod: opposite rod: 40-32JB/T3411.117—1999hi
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.