JB/T 10128-1999 Machine tool fixture parts and components stop column
Basic Information
Standard ID:
JB/T 10128-1999
Standard Name: Machine tool fixture parts and components stop column
Chinese Name:
机床夹具零件及部件 挡柱
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10128-1999 This standard specifies the stop column with a specification of 25~50mm. This standard is applicable to the prevention of workpiece movement during cutting processing on gantry planers and single-arm planers. This standard was first issued in 1983 as JB 3410-83 and revised for the first time in 1991 as GB/T 12896-91. JB/T 10128-1999 Stop column for machine tool fixture parts and components JB/T10128-1999 standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41bzxz.net
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Published
State Machinery Industry Bureau
Implementation on 2000-01-01
1 Model Park
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jies and filuresStepper
The standard specifies the specifications of 25~50m towels. This standard is applicable to planers and single-piece beds. The dimensions of the fish stoppers are shown in the following figure and table.
1999-08-06 approved by the State Bureau of Machinery Industry TE/T10129-1999
2000-01-01 Buy standard
1B/T1012-1994
6470 55;120105130 011 105030 15.5:18001040165190:22015/140 65190 220125152(175 200|230|26040
3 Marking
3.1 Tailing example:
5Umm, -150n when cake
50 x130JB/T10128—1999
JBT10128—1999
(Appendix to the environment)
Application example
Working point
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.