JB/T 3411.25-1999 Dimensions of supports for single-key broach guide bushings
Basic Information
Standard ID:
JB/T 3411.25-1999
Standard Name: Dimensions of supports for single-key broach guide bushings
Chinese Name:
单键拉刀导套用支座 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 3411.258-1999 This standard is a revision of JB 3435-83 "Single-key broach guide sleeve support dimensions". Only the following points were modified during the revision, and the main technical content remained unchanged. ——Writing format; ——Standard plus English name; ——Related reference standards and related content; ——Thread drawing method. This standard specifies the type and size of supports for single-key broach guide sleeves. The supports specified in this standard are used to install JB/T 3411.23-1999 "Single-key broach guide sleeve dimensions" and are suitable for processing 3~32mm keyways. When in use, the supports are installed on the end plate of the broaching machine. JB/T 3411.25-1999 Single-key broach guide sleeve support dimensions JB/T3411.25-1999 Standard download decompression password: www.bzxz.net
Some standard content:
1CS 25.080.07
Machinery Industry Standard of the People's Republic of China
JB/T3411,17-3411.28—1999
Accessories of broaching machines and planing machincs1999-05-20 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Support Far gaide bush for single key braach-Denses
The standard specifies the type and length of the support for the guide sleeve of a single key broach. J8/T3411.25-1999
replaces JB3435-83
4 standard and is now used for the installation of JB/3411.231999 single-key broach guide sleeve size suitable for T3-.12mm1, used for the warehouse to install on the control bed full plate three, 2 types and sizes
types and sizes are as shown in the figure and table below. A
China Machinery Industry Kitchen 1999-05-21 batch difference
2000-01-01 implementation
basic size
3 mark
limit time related
mark example:
is this size!
JB/T3411.25-1999
Depth tolerance
d-60mm, d,=150mm single chain broach with different edible support speed: 60x150bZxz.net
0JB/T3411.25[999
32: 308
Total bed medium
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.