JB/T 8037-1999 Machine tool fixture parts and components screw plugs
Basic Information
Standard ID:
JB/T 8037-1999
Standard Name: Machine tool fixture parts and components screw plugs
Chinese Name:
机床夹具零件及部件 螺塞
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8037-1999 This standard is a revision of JB/T 8037-95 "Screw plugs for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies screw plugs with thread specifications of M6×0.75~M42×1.5. This standard was first published in 1981 as GB 225-80, first revised to GB/T 2250-91 on April 30, 1991, and adjusted to JB/T 8037-95 in April 1996. JB/T 8037-1999 Machine tool fixture parts and components screw plugs JB/T8037-1999 standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Bureau of Machinery Industry
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixturesSerew plug
This standard specifies the screw plug with thread specification of M6×0.75~M42×1.5. Referenced Standards
JB/T 80371999
Replaces JB/8037—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T7001988 Carbon structural steel
JB/T8044—1999
Technical requirements for machine tool parts and components
3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 Type B
Implementation on January 1, 2000www.bzxz.net
M12×1.25
4 Technical conditions
4.1 Material: Q235-A in accordance with the provisions of GB/T700. 4.2 Other technical conditions in accordance with the provisions of JB/T8044. Marking
5.1 Marking example:
d=M24×1.5A-type screw plug:
JB/T8037—1999
Screw plug AM24×1.5JB/T8037—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.