GB/T 5645.1-1985 Flared pressure gauge pipe joint
Basic Information
Standard ID:
GB/T 5645.1-1985
Standard Name: Flared pressure gauge pipe joint
Chinese Name:
扩口式压力表管接头
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:2008-05-31
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:2008-05-31
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
GB/T 5645.1-1985 Flared pressure gauge pipe joint GB/T5645.1-1985 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China Flared type tube fittings - Connector for pressure gauge - Assembly This standard applies to flared type tube fittings for use in pipeline systems with oil and gas as the medium. CB5645.2. Marking example: JR1002-77 JE1002-7 Type A flared pressure gauge pipe fitting with outer diameter of 6mm: connector body A6 GB 5645.1-85 National Bureau of Standards Issued on November 25, 1985 G6 5647- 85 UDC 621.643.4 GB 5645.1-85 615 5616--85
LGB5648—85
1986-09-01 implementation
Answer outer diameter
M14 × 1.5
M22 ×1.5www.bzxz.net
GB5645.1-85
Technical conditions are in accordance with the provisions of GB5653-85 "Expansion Type Pipe Fitting Technical Conditions". Additional remarks:
Mass (Steel)
kg/100%
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and issued by the Standardization Research Institute of the Ministry of Machinery Industry. This standard was drafted by the Standardization Research Institute of the Ministry of Machinery Industry, Shanghai Hydraulic Card Accessories Factory, Chang Automobile Research Institute, and Shanghai Hydraulic and Pneumatic Research Institute.
This standard was drafted by Hu Bosheng, Tao Xue, and Zhang Qianlong. From the implementation of this standard, the original Ministry standard JB1917-77 "Expansion Type Pressure Gauge Pipe Fitting" will be invalid.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.