GB/T 10611-1989 Industrial mesh size series GB/T10611-1989 standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Mesh apertures of industrial meshes, size series
Wire screens and plate screens forindustrial purposes--Nominal size of aperturesGB 10611-89
This standard is equivalent to ISO2194--1972 "Industrial wire screens and screen plates-Nominal size of apertures". 1 Subject content and scope of application
This standard specifies the mesh size series of industrial meshes. This standard is applicable to metal meshes such as industrial wire woven meshes, welded meshes and perforated plates; it is also applicable to non-metal meshes made by various processing methods.
2 Reference standards
GB321 Priority numbers and priority number systems
GB6005 Basic dimensions of test sieves, wire mesh, perforated plates and electroformed sheets 3 Mesh size series
3.1 Mesh size regulations are divided into the first, second and third series, which are R10, R20 and R40 respectively. The first series (R10) is preferred. For mesh sizes less than 50μm, the size series are R10, R20 and R40.3.2 Mesh size series are shown in Table 1, Table 2 and Table 3.4 Dimension unit expression method
Mesh sizes greater than or equal to 1mm are expressed in mm (see Table 1); mesh sizes less than 1mm are expressed in μm (see Table 2 and Table 3).
(First series)
(Second series)
Approved by the Ministry of Machinery and Electronics Industry of the People's Republic of China on February 28, 1989 R40
(Third series)
Implementation on January 1, 1990
(First series)
GB 10611--89
Continued Table 1bZxz.net
(Second series)
(Third series)
(First series)
GB 10611--89
Continued Table 1
(Second series)
(Third series)
(First series)
(First series)
(First series)
GB 10611—89
Continued Table 1
(Second series)
(Second series)
(Third series)
(Third series)
(First series)
Note: 1) The rounded values ​​are taken from the R'40 series in GB321. GB10611—89
Continued Table 2
(Second Series)
(First Series)
GB 10611--89
(Second Series)
(Third Series)
GB10611--89
Appendix A
Examples of Definition of Mesh Size
(Reference)
A1 A mesh made of holes formed by interlacing metal wires or non-metallic wires. The mesh shape and size of the metal wire woven mesh are shown in Figure A1. Figure A1
A2 A mesh made of holes formed by punching or other processing methods on metal plates or non-metallic materials. The mesh shape and size of metal punching plates are shown in Figure A2.
Additional Notes:
This standard is drafted by the Machinery Standardization Research Institute of the Ministry of Machinery and Electronics Industry. The drafter of this standard is Qi Ping.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.