JB/T 8021.1-1999 Hand-pull positioners for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 8021.1-1999
Standard Name: Hand-pull positioners for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 手拉式定位器
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 8021.1-1999 JB/T 8021.1-1999 Machine tool fixture parts and components Hand-pull positioner JB/T8021.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Published
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
Hand locator
This standard specifies the hand locator with a specification of 8~15mm. 2 Dimensions
The dimensions are shown in the following figure and table.
1999-08-06 Approved by the State Machinery Industry Bureau JB/T8021.1-1999wwW.bzxz.Net
Replaced JB/T 8021.1-1995
Implemented on 2000-01-01
3.1 Marking example:
Hand-pull positioner with d=10mm:
Positioner 10JB/T8021.1---1999
JB/T8021.1-1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.