JB/T 7384.17-1994 Fastener rivet hole depth gauge
Basic Information
Standard ID:
JB/T 7384.17-1994
Standard Name: Fastener rivet hole depth gauge
Chinese Name:
紧固件 铆钉孔深塞规
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1994-07-26
Date of Implementation:1995-07-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J13 Fasteners
associated standards
Publication information
publishing house:Mechanical Industry Press
Publication date:1995-06-01
other information
Drafting unit:Machinery Standardization Research Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Fastener Standardization
Proposing unit:National Technical Committee for Fastener Standardization
Publishing department:Ministry of Machinery Industry of the People's Republic of China
Introduction to standards:
This standard specifies the type and size of the rivet depth gauge. This standard is applicable to the use of item 6 of table 1 of ZB J13 002.6. JB/T 7384.17-1994 Fastener Rivet Hole Depth Gauge JB/T7384.17-1994 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
JB/T7384.1～7384.18-94
Special Inspection Fixtures for Fasteners
Published on 1994-07-26
Ministry of Machinery Industry of the People's Republic of China
Implemented on 1995-07-01
Mechanical Industry Standard of the People's Republic of China
Fasteners
Rivet Hole Depth Plug Gauge
Subject Content and Applicable Scope
This standard specifies the type and size of the rivet hole depth plug gauge. This standard is applicable to the use of item 6 of Table 1 of ZBJ13002.6. 2 Reference standards
GB1957
Smooth limit gaugebzxz.net
ZBJ13002.6 Fastener test methods Dimensions and geometric accuracy of rivets Types and dimensions
JB/T7384.17-94
The type and dimensions of the hollow rivet hole depth plug gauge shall be as specified in Figure 1 and Table 1, and the type and dimensions of the headless rivet hole depth plug gauge shall be as specified in Figure 1 and Table 2.
Approved by the Ministry of Machinery Industry on July 26, 1994
Implemented on July 1, 1995
Nominal diameter d
Basic size
Limit deviation
Basic size
Limit deviation
Nominal diameter d
Basic size
Limit deviation
Basic size
Limit deviation
JB/T 7384.1794
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.