JB/T 10125-1999 Machine tool fixture parts and component faceplates
Basic Information
Standard ID:
JB/T 10125-1999
Standard Name: Machine tool fixture parts and component faceplates
Chinese Name:
机床夹具零件及部件 花盘
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10125-1999 This standard specifies the faceplates for saddle lathes with C-type and D-type connection methods in GB/T 5900.1~5900.3-1986 "Interchangeability Dimensions of Flange-type Spindle Ends and Faceplates for Machine Tools". This standard was first published in 1983 as JB 3399-83 and revised for the first time in 1991 as GB/T 12890-91. JB/T 10125-1999 Faceplates for Machine Tool Fixture Parts and Components JB/T10125-1999 Standard Download Decompression Password: www.bzxz.net
Some standard content:
IC5 28.060.41
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
Issued on 1999-08-06
State Machinery Industry Bureau
Implemented on 2000-01-01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures fixtoresF'accplate
JB/T10125—1999
This standard specifies the C type and D flat connection plate for horse press lathes applicable to GR/T5900.1~5900.3. 2 Reference standards
1 The clauses contained in the following standards are listed. The clauses used in this standard are the provisions of this standard. When the standard is published, the versions shown are valid. The relevant standard production department will revise it from time to time. Parties using this standard should explore the possibility of using the latest version of the underlined standard. G5000.15900.3: 1986 Machine tool flange type spindle end new and faceplate and change size 3 dimensions are shown in the following figure and table. Approved by the Machinery City Industry Bureau on 1999-08-06 C on 200-01-01 for implementation. Spindle end code PR etc. Note: The current specification of the lathe is large in size. 1 piece with the same rotation diameter. Marking
4.1 Marking example:
JB/T10125-19
Small ruler ten
139 719bZxz.net
Extreme polarization
Disk with C-type reverse connection with shaft end code 5, D-500mm: Disk C5×500JB/T[0125—1999
Disk with D-type reverse connection with shaft end code 6, D-630mm: Disk D6×630JB/T10125—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.