JB/T 8010.1-1999 JB/T 8010.1-1999 Machine tool fixture parts and components Moving plate JB/T8010.1-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Bureau of Machinery Industry
Implementation on 2000-01-01
1 Scope
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesMoving clampplate
This standard specifies the moving clamps with thread specifications of M6 to M36. 2 Reference standards
JB/T 8010.11999
JB/T8010.1—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. Technical conditions for high-quality carbon structural steel
GB/T699—1988
JB/T8044—1999
3 Dimensions
Technical requirements for machine tool components and parts
The dimensions are shown in the following figure and table.
4 Technical conditions
4.1 Material: 45 steel according to the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions shall comply with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
A-type movable platen with nominal diameter = 6mm and L = 45mm: Platen A6×45JB/T8010.1—1999Www.bzxZ.net
Approved by the State Machinery Industry Bureau on August 6, 1999 and implemented on January 1, 2000
JB/T 8010.11999
Nominal diameter
(Melt diameter)
JB/T 8010.11999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.