This standard specifies the requirements and inspection methods for the geometric accuracy and working accuracy of gear chamfering machines. This standard applies to cylindrical gear chamfering machines with a maximum workpiece diameter of 125~500 mm. JB/T 8484-1996 Gear chamfering machine accuracy inspection JB/T8484-1996 Standard download decompression password: www.bzxz.net

The Machinery Industry Standard of the People's Republic of China
JB/T8484--96
Gear Chamfering Machine
1996-11-07 ReleasewwW.bzxz.Net
Precision Inspection
1997-01-01 Implementation
Ministry of Machinery Industry of the People's Republic of China
JB/T8484-96
This standard is formulated to meet the needs of the rapid development of the automobile, heavy truck and other industries, based on the production experience of gear chamfering machines in my country and the basis of strict inspection documents of foreign countries. This standard is issued by the National Standardization Technical Commission of the State Council: The standard is issued by the Three Quality Gear Machine Tool Research Institute: This standard was established by: Qing Machine Tool Factory, Nanjing Second Machine Tool Factory. 1 Scope
Machinery Industry Standard of the People's Republic of China
Gear chamfering machine,
Precision inspection
This standard specifies: the requirements and inspection methods for the geometric accuracy and working accuracy of gear chamfering machines. This standard is used for circular gear chamfering machines with large workpiece diameters of 125+-5001mm. 2 References
J/T8484-96
The provisions contained in the following standards are referenced in technical standards to form technical standards. When the standard is published, the versions shown are valid. All standards will be revised. The parties to this standard will discuss the possibility of using the latest versions of the following standards. TB2570-8 Gold Medal Cutting Machine Tool Precision Inspection General Rules 3 General Requirements
3.1 Interpretation of the provisions in 3.1 of JB267-82 to adjust the safety level of some machine tools. Place the level on the workbench or the special plate for the bed rails. The level should not exceed (04/1UU) in both the numerical and numerical directions. 3.2 The marking must refer to JB2670, especially the installation before the test, the stability of the main frame and other components, the inspection method and the accuracy of the inspection. 3.3 The standard sequence length is selected according to the structure of the machine tool. 3.4 The inspection sequence can generally be based on the numerical control inspection and the inspection convenience. 3.5 When the measured length is different from the standard, the difference should be converted according to the measurable length according to the provisions of 2.3.1.1 in JB267082. When the conversion result is less than +0.005mm, it is still within 0.005mm. Approved by the Ministry of Machinery Industry on November 0, 1996, implemented on March 1, 1997, JB/T8484-96, GO2002, on cus, 8484--96, 020'0+$13, 002 02, 8484-96, 020'0+$13, 002 02, 8484-96, 020'0+$13, 002 02, JB/T 8484-96
a't--9
every day
ogn can
002GG2
Chinese famous doctor program hall
Yao Daiwei
5 working degree
JB/T 8484-9f
The size of the test piece, materials and technical requirements shall be determined by the manufacturer through consultation or by the manufacturer. The internal correction shall not be less than 9.20mm: the maximum allowable value of the plasticity difference R is 12.Sum,
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.