JB/T 9160.19-1999 Dimensions of rear tool holder for single-spindle turret automatic lathe
Basic Information
Standard ID:
JB/T 9160.19-1999
Standard Name: Dimensions of rear tool holder for single-spindle turret automatic lathe
Chinese Name:
单轴转塔自动车床辅具 后刀座尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tool Devices>>25.060.20 Indexing and Tool/Workpiece Holding Devices
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:State Machinery Industry Bureau
Introduction to standards:
This standard specifies the type and size of the rear tool holder for single-spindle turret automatic lathes C1325 and C1336. JB/T 9160.19-1999 Dimensions of rear tool holder for single-spindle turret automatic lathes JB/T9160.19-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC525.080.01
Machinery Industry Standard of the People's Republic of China
JB/T9160.1~-9160.2U—199
Accessories of single spindle turret automatic lathes
Accessories of single spindle turret automatic lathes1999-05-20 Issued
State Bureau of Machinery Industry
Implementation on 2000-01-01
1 Scopebzxz.net
Machinery Industry Standard of the People's Republic of China
Accessories of single spindle turret automatic lathes
Back tool holder dimensions
Accessories orsingle spindio turretautomalk lethesBehind postDimensions
This standard specifies the dimensions of single spindle turret automatic lathes. 4. This C25, 133! The reference standard JB.T9160.19-1999 is used to indicate the provisions of the standard. The referenced parts in this standard constitute the provisions of this standard. The date of publication of this standard is not valid. All standards are recommended to be used as follows: The following standards should be used when using this standard. GD/T158-1996 Standard T-shaped and subtractive screw control types and dimensions for machine tools. The types and dimensions are as specified in the figure below. Approved by the State Machinery Industry Bureau on May 20, 2000-0[-01 Implementation: BT9160.19 JB/1010.19-190
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.