JB/T 8029.1-1999 JB/T 8029.1-1999 Machine tool fixture parts and component support plates JB/T8029.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01 Standard of the Machinery Industry of the People's Republic of Chinawww.bzxz.net Parts and components of jigs and fixtures The parts and units of jigs and fixtures1999-08-06 Issued State Machinery Industry Bureau Implementation on 2000-01-01 Standard of the Machinery Industry of the People's Republic of China Parts and components of jigs and fixtures Supporting plate The parts and units of jigs and fixturesSupporting plate This standard specifies the supporting plate with a specification of 6~25mm. 2 Referenced standards JB/T8029.1—1999 Replaces JB/T8029.1—1995 The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T1298-1986 Technical conditions for carbon tool steel JB/T8044-1999 Technical requirements for machine tool fixture parts and components 3 Dimensions The dimensions are shown in the following figure and table. Approved by the State Machinery Industry Bureau on August 6, 1999 206 Implemented on January 1, 2000 4 Technical conditions 4.1 Material: T8 in accordance with the provisions of GB/T1298. Heat treatment: 55~60HRC. JB/T8029.1-1999 4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 Marking 5.1 Marking example: A-type support plate with H=16mm and L=100mm: support plate A16×100JB/T8029.1—199915 Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.