GB/T 5629.2-1985 Flared tapered thread right angle pipe fitting body
Basic Information
Standard ID:
GB/T 5629.2-1985
Standard Name: Flared tapered thread right angle pipe fitting body
Chinese Name:
扩口式锥螺纹直角管接头体
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:1986-09-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1986-09-01
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:National Bureau of Standards
competent authority:China Machinery Industry Federation
Introduction to standards:
This standard applies to taper thread right angle pipe fittings for pipeline systems with oil and gas as the medium. GB/T 5629.2-1985 Flared taper thread right angle pipe fittings GB/T5629.2-1985 Standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Flared type tube fittings--www.bzxz.net
Male elbow-Body
This standard applies to the straight-use tube fittings with tapered threads in the pipeline system with oil and gas as the medium. Standard ratio example:
A-type flared chain thread point angle tube fittings with an outer diameter of 10mm. Connector body A10GB5629.2—85
National Bureau of Standards 1985-11-25 Issued
UDC621.643.4
GB5629.2--85
1986-09-01 Implementation
M10× l
M12x1.510
[M14×1.511.7
da d ts
GB5629.2-85
9.54.520.5
M16x1.513.7
M18×1.51
M22×1.519 .713
M24×1.321.715
M27×1.524.7
M30×2
M33×2
M36×2
M39 ×2
M42×2
M45×2
2115.56.535.5
9.5 j52.3
Technical conditions shall be in accordance with the provisions of GB5653-85 "Technical conditions for flared pipe joints". 2
Type A and B
Material (steel)
kg/100 pieces
Additional instructions:
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and approved by the Standardization Research Institute of the Ministry of Machinery Industry. 4.29
This standard was drafted by the Standardization Research Institute of the Ministry of Machinery Industry, Shanghai Hydraulic Accessories Factory, Changchun Automobile Research Institute, and Shanghai Hydraulic and Pneumatic Research Institute. The main drafters of this standard are Hu Lu, Li Ningning, and Zhang Qianlong.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.