JB/T 9984.1-1999 This standard is a revision of ZB J61 009-89 "Parameters of Through-type Shot Blasting Machines". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the parameters of through-type shot blasting machines. This standard is applicable to through-type shot blasting machines with roller conveyors. This standard was first issued in March 1989. JB/T 9984.1-1999 Parameters of Through-type Shot Blasting Machines JB/T9984.1-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS77.180 Machinery Industry Standard of the People's Republic of China JB/T9984.19984.2—1999 Through-type shot blasting machine Published on 1999-05-14 National Bureau of Machinery Industry Implementation on 2000-01-01 J815984.1-0 This standard is a revision of ZBJ6[00989 Parameters of Through-type Shot Blasting Machine]. During the revision, only the relevant regulations were revised, and the technical content was not changed. This standard replaces ZBJ61009·89 from the date of implementation. This standard was proposed and issued by the National Foundry Machinery Standard Technical Committee, and the responsible drafting unit of this standard is: Xiaopan Foundry Machine". This standard was first issued in March 1989: Machinery Industry Standard of the People's Republic of China Through-type shot blasting machine This standard specifies the requirements for through-type shot blasting machines. This standard applies to through-type dirty shot blasting machines (hereinafter referred to as machines) with conveying. Reference standards FB/T9984.1-1959 Represents the following items—89 The provisions contained in the following standards are referenced in this standard and constitute the provisions of this standard. When this standard is published, the version shown is valid. All specifications are subject to revision. The parties using this standard should consider the possibility of using the following new versions. JB/T3713.11999 Basic parameters of double-disc shot blasting machine 3 Definitions 3. Effective cleaning width The width of the trace left by the projectile in the front direction of the workpiece: the width of the trace left by the projectile. The width of the trace is less than 95% of the coverage of the bullet mark. 3.2 Feeding speed The speed of the next piece when it passes through the shot blasting area of the shot blasting machine. 4 Basic parameters 4.1 The basic parameters of the machine are effective for cleaning: 4.2 The basic parameters of the machine should comply with the provisions of the table. 1 Special cleaning sequence bzxz.net Shot blasting machine total shot blasting disc ke'min Yixuan connection length Pregnant piece commercial length Pregnant piece height 15:200 This: If the pin plate is used at the same time, the total shot blasting is the highest: 4.3 The shot blasting machine used in the machine meets the requirements of 1B/13713.1. Approved by the Industrial Bureau of Kitchen Machinery City on 1999-05-14 1250 ¥1250 25:1600 2000-01-01 Implementation Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.