GB/T 5625.2-1985 Flared end straight pipe fittings
Basic Information
Standard ID:
GB/T 5625.2-1985
Standard Name: Flared end straight pipe fittings
Chinese Name:
扩口式端直通管接头体
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:1986-09-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1986-09-01
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Research Institute of the Ministry of Machinery
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
GB/T 5625.2-1985 Flared end straight pipe fitting body GB/T5625.2-1985 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Flared type tube fittings-
Straight thread connector -B odyThis standard applies to flared type tube fittings-for piping systems using oil and gas as media. Marking example:
The flared end straight-through pipe fitting body with an outer diameter Da of 10mm: Fitting body 10GB5625.2-85
National Bureau of Standards 1 85-11-25 Issued
UDC 621.643.4
GB 5626-2 --85
Implementation on 1986-09-01
(Xiang) Li
74 ± 0.5
1 9*[×8W
g*1×g
S\T×I
1 ×OTWwww.bzxz.net
g'1xzlW
GB5625.2-85
Technical conditions shall be in accordance with the provisions of GB563-85 "Technical Conditions for Flared Pipe Fittings". This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and upgraded by the Standardization Institute of the Ministry of Machinery Industry. This standard was initiated by the Standardization Institute of the Ministry of Machinery Industry, Shanghai Hydraulic Accessories, Changchun Automobile Research Institute, and Shanghai Hydraulic and Pneumatic Research Institute. The main drafters of this standard are Hu Lusheng, Li Ningning, and Zhang Long. From the date of implementation of this standard, the original ministry standard JB1921-77 "Flare-end straight-through pipe fittings" will be invalidated.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.