Some standard content:
TCS±65.100
Chemical Industry Standard of the People's Republic of China
(2000)
Published on 2000-06-05
Implementation on 200103-01
Published by the State Administration of Petroleum and Chemical Industry
Registration No.: 7487-2000
H32892000
This standard is based on the specifications of the mancozeb sizing agent in the FAO coating drug specifications and combined with the actual domestic production This standard is revised from the chemical industry standard TIG3289-1952 Zineb Recyclable Test Agent. The main technical differences between this standard and HG3289-1982 are: 65% wettable powder specification is added: the control item of volume floating rate is added, and the daily index is greater than or equal to 50%, and the accelerated storage test is added: the original less than or equal to 1.0min is changed to less than or equal to 2.0min when the moisture is shown: the pH value is changed from ~ to 5.0~9., which is consistent with the FAO standard. This standard will replace HG3289-1982 from the date of implementation. This standard is proposed by the Technical Supervision Department of the former Ministry of Chemical Industry of the People's Republic of China, and this standard is under the jurisdiction of the Tongyang Chemical Research Institute. The unit responsible for the change of the standard is Shenyang Pesticide Factory. The main drafters of this standard are Xu and Shang. This standard was first issued in December 1965. This is the second revision. The Secretariat of the National Agricultural Standardization Technical Committee is responsible for the revision: s.
Chemical Industry Standard of the People's Republic of China
Zincb Wettable Powder
Zincb Wellaule Powders
Other names, structural formulas and basic physical and chemical formulas are as follows: Es0 Common name: 7.ineh
CIPAC mathematical code: 25
Chemical name: 2-7-ylidene dihydrogen aldehyde zinc structural formula,
IIC--NC
-NIJ--
Empirical formula: 1.1v.S.2n
Molecular mass: 27.7 (according to 1995 International standard for atomic mass (small objects in active state); solubility: 1\duotin in water. Incompatible with most organic solvents, slightly soluble in water, compatible with some integrators such as EDTA, but without tax. Qualitative properties: unstable to light, heat and moisture within 1 range. This standard specifies the requirements for hygroscopic agents, test methods and specimens, labels, packaging, purchase and transportation. This standard is applicable to the free-flowing powder of mancozeb made from the original zinc compound that meets all the standards and suitable fillers and additives. 2 Referenced standards
The following standards contain the provisions and constitute the provisions of this standard through reference in this standard. At the time of this standard, the versions shown are valid. The relevant standards will be revised from time to time. The parties using this standard shall use the latest version of the following standards. GB/T 611988 Chemical reagents for the preparation of standard reduction for analysis of pesticide water content (volume analysis) C:/-33--1979 (108) Method for determination of moisture content of pesticides
GRT IGU:
GT16011995Commodity acceptance inspection
1H:1605-137(1989)Commodity agricultural standard group method GB3795-Pesticide package general financial
545_-1Anti-removable number of agents for determination of wettability GB.*
1+F25 -1331
An medicine with the method of determining the elasticity of the roadside treatment 161501935
Pesticides can be used for the determination of ... roadside treatment 161501935
Pesticides can be used for the determination of the roadside treatment 161501935
Pesticides can be used for the determination of the roadside treatment 161501935
Pesticides can be used for the determination of the roadside treatment 161501935
Pesticides can be used for the determination of the roadside treatment 161501935
Pesticides can be used for the determination of the roadside treatment 161501935
Pesticide Select the content, 5
water content production.
zezu,
zhou wet blood
group special (must be small r standard total cloth
production: the following belt ten times add trace test heart every 3 grid selection change. 4 method test method
.1 oil itch
cause B door 16C--.!31\adhesive and wettable powder "method to make the monthly sampling determined by the number of samples but pretend to be a small number of dry samples.
4.2 monitoring test...*-drip ratio test (CIPA\MT130>4.2. 1 Test and skin apparatus
acidic double shock liquid: this = more / household double colony comprehensive natural flow rate 2m! Blood people glacial acetic acid. 23ml. Release a nitrogen in the process to [ml. is
calcium oxide melt: 4/,
release: whalrinN1 when
point: point Xie fixed capillary.
4.7.7 operation step apparatus
4-2.2 ~ point "Xie fraud wwW.bzxz.Net
weigh the test drug) 5 more, such as people ~3mL... in the system: fully stir, so that the sample is collected. And point the diagram will make the middle point to the appropriate size on the chain level, 7 lines of three lines, each line of three points of the requirements is the center of the coordination point directly to the drug, weigh the point of the outside state evil heat (township ring diameter 20 points after completion, then its square cool ten. 4.7 2. 2
Test 1: Use a spotter to absorb the acid solution quickly, and drop it on the second spot. If the center of the spot is pink and the outer ring is pink, the sample is a synthetic resin.
Test 2: Use a dropper to absorb the chemical solution, and drop it on the third spot. The center of the spot is white, and the color is bright red.
Test 3: Use a dropper to absorb the oxidized solution and the acid solution, and drop it on a spot. If the center of the spot is pink and the outer ring is pink, the sample is a synthetic resin. 4.3 Determination of Zineb Content
4.3.15 Method Summary
[1G32892000
The sample is decomposed in the sulphur wave to generate magnetic sulphide and hydrogen sulfide gas, which is then absorbed by acetic acid, followed by the absorption of ethyl sulfide and the production of potassium disulfide. The ethyl sulfide is neutralized by titration with standard solution, the formula is: C,H,N,4H2O+NHE[,CII.NII)-HS,+2CS.+2.*S-CH.OK C,H,OCSSK
2C.H.OCSSK:C,H,OC(SiSsS)CC.-2K14.3.2 Reagents
Acid solution:
Acetic acid: 0)g
Glacial acid solution: Glacial acid: Water =! ".
Self-chemical mail/etc. wear business: 110, before use. Standard drop Zong Xi tax cI/red.=uo in, according to GB preparation and standard. Resource tree indicator wave: gate..
Nan resistant index bottle: 10g/Z. Storage rate liquid:
4.3.3 Record only, equipment
Decomposition and - and - women's clothing see Figure 1,
Training mood gas liquid
reaction (wear a type of cold Energy 3 long protection: the first set back: the first absorption case storage decomposition and absorption table set || tt || 4.3.4 determination steps || tt || gently take the test column containing 4 sulfadiazine drops accurate to (2, put in the first branch tube ten add 0m ethyl calcium catabolite drop liquid, the first whole tube 6m potassium oxide 7 sequence filter, or use [continuous decomposition and absorption transfer, check the sealing of the bone, add cold water, and start the suction source. Control the suction speed to 2 per second ~4 gas and liquid can be transferred through the absorption tube. Add 5ml of acid to the reaction bottle through the long pre-sliding bucket, stir and control the heat immediately, keep the reaction liquid at a low temperature for 13min, and store it at a low temperature. Transfer the liquid in the absorption tube to 5cctrl of water, and wash it with 235ml of water, then wash it into 500ml of solvent, and adjust the absorption tube to the indicated position, and wash it to the inside of the tube. No residue, neutralize with acetic acid until the color is white, then build up the volume, drip, immediately filter with the test solution, while constantly stirring, the end point is 1\m. Continue to titrate with the test solution until the test solution turns blue, which is the end point.
H3289-2000
The content of the test solution expressed as a molar fraction (%) is calculated according to formula (1), xc(-V)x0.12 Dx100
.137 0
The actual concentration of the standard drop solution, nol/L.-The volume of the sample solution, ml.R-The volume of the clear white solution in the standard storage, mL.F(1)
and 1.00sI standard titration dissolution [c(1/2I=1.C00 heart" equivalent to the amount of zinc expressed as a substitute for the drug, 2.3.E light explosion coupon
two parallel determination results, the elemental zinc can be significantly increased dose should not be more than 12 tablets can be six pieces of powder should be 1.0 Xing. Collect the half mean value as the other determination results, 2.4 Determination of moisture
2.4.1 Determination method
love/639 1979-1985> Market \ Its violation of the heat inquiry method \ Implementation, 5.4.7 The relative deviation of the two parallel determinations shall not be taken from the above 13 The average value of the final calculation shall be taken as the determination result 4.5 Determination of pH value \ _ ... ,Use a good tube to collect all the remaining floating liquid and sediment, transfer to a grid car, low reaction, rinse with a little water, and put all the materials in the bottle, 1.3., the actual measurement of zinc dosage should be no more than 4.6.2 yuan per ticket, and the result should not exceed two and a half times. Collect the half-mean value as the measurement result, 4.7 Determination of wetting time according to G6T515 [4.8 Determination of fineness (K261501995 "source sieve method is not carried out", 1.9 Accelerated storage test 4-9.1 Instruments and equipment | Constant temperature box, (
burning system:. Inner diameter -6.m
plate: size and burning are also matched, Yiyi produces an average pressure of 3.4P』4.9.2 test dew
Put the test tray into the cup, do not add any pressure to the other side of the flat layer. Put the filter plate on the test, put the beaker』dry 11, under, storage 1, take this burning, pregnant plate, put it into the ten-piece, make the test rod to the room benefit according to 1 pass through the zinc content should not be lower than the average content of the heart. 4.10 product inspection and acceptance
complete (E1 specification: plate limit value at about the lower than the whole method: 3| |tt||5 Marking, labeling, packaging, storage and transportation
c3289—2000
5.1 The marking, labeling and packaging of the zinc-containing powder shall comply with the provisions of GB676. 5.2 The zinc-containing powder shall be packed with a layer of kraft paper with a plastic inner layer. Each tray contains 10kg or 20kg. 5.3 Other types of packaging may be used according to user requirements or product agreements, but they must comply with the provisions of GB476: 5.4 The assembled parts shall be stored in a well-ventilated and low-temperature workroom. 5.5 During storage, it shall be kept strictly away from moisture and humidity. It shall not be mixed with food, seeds, or other materials. Avoid contact with skin. Prevent people from getting sick from the nose or mouth. 5.6 Safety: Mancozeb is a low-toxic disinfectant. When using this product, you should pay attention to personal protection and wear protective equipment. Wash the exposed skin with fertilizer and water after application. If there is any poisoning, seek medical attention in time and receive symptomatic treatment. 5.7 Warranty period: Under the specified pollution conditions, the warranty period of Mancozeb wettable powder is one year from the month of production. From the date of production to one year, for 8% mancozeb wettable powder, the monthly decomposition rate of mancozeb should not be higher than (10%, from one year to two years). For 65% mancozeb wettable powder, the monthly decomposition rate should not be higher than 0.65% and 0.32%, respectively.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.