GB/T 9104.6-1988 Test method for industrial stearic acid - Determination of water content
Basic Information
Standard ID:
GB/T 9104.6-1988
Standard Name: Test method for industrial stearic acid - Determination of water content
Chinese Name:
工业硬脂酸试验方法 水分的测定
Standard category:National Standard (GB)
state:Abolished
Date of Release1988-04-30
Date of Implementation:1989-01-01
Date of Expiration:2008-12-01
standard classification number
Standard ICS number:Chemical Technology>>Organic Chemistry>>71.080.40 Organic Acid
Standard Classification Number:Chemicals>>Organic Chemical Raw Materials>>G17 General Organic Chemical Raw Materials
Publication information
publishing house:China Standards Press
Publication date:1989-01-01
other information
Release date:1988-04-30
Review date:2004-10-14
Drafting unit:Daily Chemical Research Institute of the Ministry of Light Industry
Focal point unit:National Technical Committee on Standardization of Surfactants and Detergents
Publishing department:China Light Industry Federation
competent authority:China Light Industry Federation
Introduction to standards:
GB/T 9104.6-1988 Test method for industrial stearic acid. Determination of moisture. GB/T9104.6-1988 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Test methods for industrial stearic acids.-.Determination of water content1 Subject content and applicable diagram
This standard specifies the method for the determination of water content in industrial stearic acid. UDC 668. 1. 012
：543.06
GB 9104.6---88
This standard applies to the determination of water content in industrial stearic acid produced by pressing or distillation after hydrolysis of animal and vegetable fats. It is not applicable to fatty acids containing less than dodecanoic acid.
2 Apparatus
2.1 Constant temperature oven.
2.2 Weighing bottle 50mL, low type. bzxz.net
3 Test procedure
Accurately weigh about 10g of sample into a clean weighing bottle with constant weight, put it into a constant temperature oven at 105±1℃, remove the lid of the weighing bottle and dry it for 2h, then cover it, take it out and put it into a desiccator to cool for 30min before weighing. 4 Calculation of results
mo - mi × 100
Where: A—
water acid content, %,
sample mass, g;
mi -sample mass after drying, g.
The allowable error of parallel test results is 0.02%. Additional remarks:
This standard is proposed by the Ministry of Light Industry of the People's Republic of China. This standard is under the technical jurisdiction of the Daily Chemical Industry Science Research Institute of the Ministry of Light Industry. This standard is drafted by the Daily Chemical Industry Science Research Institute of the Ministry of Light Industry. This standard is equivalent to the Japanese Industrial Standard JIS K3331 "Industrial Hardened Oil Fatty Acids" Determination of moisture and volatile matter - oven method.
Approved by the Ministry of Light Industry of the People's Republic of China on April 30, 1988 and implemented on October 1, 1988
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.