JB/T 10119-1999 Machine tool fixture parts and components retaining rings
Basic Information
Standard ID:
JB/T 10119-1999
Standard Name: Machine tool fixture parts and components retaining rings
Chinese Name:
机床夹具零件及部件 卡环
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 10118-1999 JB/T 10119-1999 Machine tool fixture parts and components retaining ring JB/T10119-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures for machine tools
llk'paris and units ufjigswud rixturesSnapring
This standard specifies the snap rings suitable for parts with a diameter of 5~12mm. The sizes are shown in the table below.
Approved by the State Machinery Industry Bureau on September 6, 1999
JBT09-
Implementation of 2000-01-U1
Nominal diameter
[Applicable, allowable point diameter]
>10~15
>20~25
>25 ~ 32
>32 -6
> G: ~ 1
> 50 60
>7g ~80bzxz.net
> 80 90
> 9 -- 1
100~1u
>110-115
3 Marking
3.1 Marking example:
Snap ring with nominal diameter of 10~[5:
Snap ring 10-15JB/T10119—1999
JB10119—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.