JB/T 8045.5-1999 Machine tool fixture parts and components Drill sleeve screws
Basic Information
Standard ID:
JB/T 8045.5-1999
Standard Name: Machine tool fixture parts and components Drill sleeve screws
Chinese Name:
机床夹具零件及部件 钻套螺钉
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8045.5-1999 This standard is a revision of JB/T 8045.5-95 "Drill Sleeve Screws for Machine Tool Fixture Parts and Components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies drill sleeve screws with thread specifications of M5 to M10. This standard was first issued in 1981 as GB 2268-80, first revised to GB/T 2268-91 on April 30, 1991, and adjusted to JB/T 8045.5-95 in April 1996. JB/T 8045.5-1999 Drill Sleeve Screws for Machine Tool Fixture Parts and Components JB/T8045.5-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixturesDrill sleeve screw
This standard specifies the drill sleeve screws with thread specifications of M5~M10. 2 Referenced standards
JB/T8045.5—1999
Replaces JB/T8045.5—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699-1988 Technical conditions for high-quality carbon structural steel JB/T8044-1999 Technical requirements for machine tool fixture parts and components 3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 266
Implemented on January 1, 2000
Basic dimensions
4, Technical conditions
Limit deviation
JB/T8045.5-1999
Basic dimensions Www.bzxZ.net
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
d=M10, L,=13mm drill sleeve screw:
screw M10×13JB/T8045.5—1999
limit deviation d11
drill sleeve inner diameter
>6 -12
>t2~30
>30 ~85
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.