JB/T 2001.11-1999 Types and dimensions of square flanges for water systems (PN=10MPa)
Basic Information
Standard ID:
JB/T 2001.11-1999
Standard Name: Types and dimensions of square flanges for water systems (PN=10MPa)
Chinese Name:
水系统 方附接法兰 型式与尺寸(PN=10MPa)
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-06-28
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Fluid systems and general parts >> 23.100 Fluid power systems
Standard Classification Number:Machinery>>General Parts>>J20 Hydraulic and Pneumatic Devices
Publication information
other information
Focal point unit:Metallurgical Equipment Standardization Technical Committee
Publishing department:Metallurgical Equipment Standardization Technical Committee
Introduction to standards:
JB/T 2001.11-1999 This standard is a revision of JB 2011-84 "Hydraulic press square attachment flange type and size (Pg = 100 × 100000Pa)". This standard specifies the type and size of square attachment flanges. This standard is applicable to hydraulic systems with a nominal pressure of 10MPa. This standard was first issued on January 1, 1984. JB/T 2001.11-1999 Water system square attachment flange type and size (PN = 10MPa) JB/T2001.11-1999 standard download decompression password: www.bzxz.net
Some standard content:
IC.s$ 23.110
Machinery Industry Standard of the People's Republic of China
JB/T 2001.1~2001.74—1999
Water system components
Water system assembly and parts1999-06-28 Issued
National Machinery Industry Bureau
2(-01-U1 Implementation
Machinery Industry Standard of the People's Republic of China
Water system
Square attached flange
Type and size
Water system-Square attached flangeTypeaadsice
PN=10 MPa)
This standard specifies the types and sizes of some attachment methods. This standard is applicable to wave pressure systems with a nominal pressure of 10MPa. The provisions contained in the referenced standard
JAT2001.1E—1999
Rong 2911-4
constitute the provisions of this standard through reference in this standard. This standard is published as of: The editions shown are valid. All standard departments and parties using technical standards should explore the possibility of using the latest edition of the following standards: JH20015-999 Types and sizes of copper barriers for water systems 3 Types and sizes
3.1 The type should comply with the provisions of two:
d D, 2 5
2-Frequency: 3-Flange: 4-Connection: 5 Copper pad Figure 1 www.bzxz.net
Approved by the National Machinery Industry Bureau on 1999-06-28 Implementation on 2000-01-01
JB/T2001.11-199g
0912210E1
521:11100 1/8
5[[1002
tT Lar
Elllooz Lut
HEI1G0K LHI
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.