Technical data of Type DB-443 electronic glass
Basic Information
Standard ID:
SJ/T 10588.15-1994
Standard Name:Technical data of Type DB-443 electronic glass
Chinese Name:
ＤＢ－４４３型电子玻璃技术数据
Standard category:Electronic Industry Standard (SJ)
state:Abolished
Date of Release1994-08-08
Date of Implementation:1994-12-01
Date of Expiration:2008-01-20
standard classification number
Standard Classification Number:General>>Standardization Management and General Provisions>>A01 Technical Management
associated standards
alternative situation:SJ 2412-83
Publication information
other information
Introduction to standards:
SJ/T 10588.15-1994 Technical data of DB-443 electronic glass SJ/T10588.15-1994 Standard download decompression password: www.bzxz.net
Some standard content:
Electronic Industry Standard of the People's Republic of China
Technical data of type DB-443 electronic glass
Technical data of type DB-443 electronic glass Subject content and scope of application
This standard specifies the chemical composition and physical and chemical performance indicators of DB-443 electronic glass. This standard applies to glass materials used in the neck of color picture tubes. 2 Reference standards
GB9000
GB9622
GB/T14012
Technical requirements
Standard method for chemical analysis of electronic glass
Test method for physical and chemical properties of electronic glass
General specification for glass shell of black and white picture tubes
Chemical composition is shown in Table 1.
Chemical composition
Weight percentage
47.80±1.00
3.50±0.15
1.50±0.10
2.00±0.10
2.70±0.15bzxZ.net
9.60±0.15
32.50±0.20
Note: 1) Fe, O, as impurity control, are not counted in the percentage composition. 3.2 Physical and chemical performance indicators are shown in Table 2.
The Ministry of Electronics Industry of the People's Republic of China approved SJ/T10588.15-94 on August 8, 1994
Replaced SJ2412-83
Test method
GB9000.11
GB9000.10
GB9000.12
GB9000.14
Implemented on December 1, 1994
Indicator name
SJ/T10588.15-94
Average linear thermal expansion coefficient α in the range of 0~300℃Density
Softening point
Annealing point| |tt||Strain point
Volume resistivity Igp at 350℃
X-ray absorption coefficient (0.06nm, 20.6KeV) 1/℃
(96.5±0.8)×10-7
3.285±0.015
643±3
466±5
422±5
Test method
GB9622.8)
GB/T14012
Article 4.5.4
Note: 2) Articles 4.5 and 4.6 are combined and carried out as follows: The measurement starts from the starting point, keeps warm at 300℃ for 10 minutes, and then starts the measurement. Continue to increase the furnace temperature, and make measurements every time the temperature rises by 10℃ until the measurement ends at 390℃. Additional Notes:
This standard is under the jurisdiction of the Standardization Institute of the Ministry of Electronics Industry. This standard was drafted by Factory 4400 and the Standardization Institute of the Ministry of Electronics Industry. The main drafters of this standard are Li Guanghui, Liu Chengjun, Bai Yixiang, and Duan Zifa. This standard was first issued on December 5, 1983 and revised for the first time on August 8, 1994. 2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.